These formulae are suitable for any contacting point of tooth surface meshing.
这些公式适用于齿面啮合的任何接触点。
The motion optimization method is proposed, by which transmission errors anddiscontinuousness of tooth surface meshing is decreased to minimum.
提出了运动优化的方法，通过预设传动误差抛物线函数，使齿面啮合时运动误差和不连续性减至最小。
A mathematical model of spiral bevel gear tooth surface was built by analyzing manufacture method and meshing theory.
通过分析锥齿轮的加工方法和齿轮啮合理论，建立了螺旋锥齿轮齿面数学模型。
The error correction model of tooth surface was established by machine tool adjustment parameters and meshing principle.
结合机床调整参数、齿轮啮合原理，建立了螺旋锥齿轮齿面误差修正模型。
The results show that the micro rotational Angle induced by the tooth surface elastic deformation has definite effect on meshing points.
结果表明，齿面弹性变形引起的齿轮轮齿的微小转动对啮合点的最终位置有一定的影响。
The micro angle induced by the tooth surface elastic deformation causes the change of meshing points. Quasi-Hertzian analysis is defined as the process of tooth meshing analysis.
将齿轮因齿面变形而产生微小转角，继而进行齿面啮合分析的过程定义为拟赫兹接触分析。
Equations for describing the tooth surface of a face-gear were established, and the contact path was formed by differential geometry and meshing theory.
推导了双圆环面包络环面蜗杆磨齿啮合界线方程及其与相配蜗轮啮合的啮合界线方程。
Equations for describing the tooth surface of a face-gear were established, and the contact path was formed by differential geometry and meshing theory.
推导了双圆环面包络环面蜗杆磨齿啮合界线方程及其与相配蜗轮啮合的啮合界线方程。
应用推荐