The experiment results show that the influence of tip linear velocity, working density, repeated level and their reciprocities on the cutter's working quality is remarkable.
试验结果表明，甩刀末端线速度、甩刀工作密度、甩刀重复度及其交互作用对切碎机工作质量影响显著。
With the Doppler laser vibration measurement system, the vibration velocity curves of the flip chip and tool tip were obtained during thermo-sonic flip chip bonding.
采用多普勒激光振动测量系统，获得了热超声倒装键合过程中工具末端及芯片的振动速度曲线。
The velocity vector and vortical contour in three different circumference positions were successfully acquired and the structure of the tip leakage vortex was clearly illustrated.
测量得到了三个不同周向位置下的涡量图和速度矢量图，并观测到了叶顶泄漏涡的涡旋结构。
In the experiment, the X-ray testing system takes pictures of the jet formatting and stretching. According to the pictures, we can calculate the jet tip average velocity.
实验工作用X光拍摄射流形成过程和射流运动姿态，通过X光片测出射流头部平均速度；
Finally, with the introduction of a fast varying zone ahead of the crack tip, a solution with fully continuous stress and velocity fields is obtained.
最后，通过在裂尖前方引人一快变化区，本文得到了一个在裂尖周围应力和速度全连续的渐近解。
The results of this simulation showed that the maximum temperature appears at the tip of the blade. And the particle velocity will reach the maximum value at the end of the blade finally.
模拟结果表明，叶片出口端部前缘，温度达到最大，颗粒的运动速度也达到最大值。
Meanwhile, with rising in anisotropic value, the growth velocity of dendritic tip is promoted with decreasing in curvature radius.
各向异性强度越大，枝晶尖端的生长速度越快，曲率半径越小。
The effect of the tip mass becomes large along with the increasing of angular velocity of the large motion of the system.
附加质量的影响随系统大范围运动的角速度的增大而变大。
The circumferentially averaged velocity distribution of the radial velocity is distorted when the hub/tip ratio is 0.325.
轮毂比0.325时，周向平均径向速度分布出现明显“畸变”。
The circumferentially averaged velocity distribution of the radial velocity is distorted when the hub/tip ratio is 0.325.
轮毂比0.325时，周向平均径向速度分布出现明显“畸变”。
应用推荐