Crusher downtime, check whether firmly and tighten bolts of wear parts wear degree, whether to need replacing.
破碎机停机时，要检查紧固螺栓是否牢固和易磨损部分的磨损程度，是否需要更换。
Annual check and tighten all the screws, bolts and fixing device.
每年检查并拧紧所有螺钉、螺栓和各种固定装置。
Therefore, in the concrete foundation with anchor bolts and tighten the flange crane chassis, because the foundation is uneven, 4 flange may not be in the same plane.
因此，在用地脚螺栓将混凝土基础与塔机底架法兰盘拉紧后，由于基础不平，4个法兰盘不可能在同一平面上。
Check each component installation location is mobile, deformation, tighten all bolts, check the sealing is good or not.
检查各部件安装位置是否移动、变形、锁紧所有螺栓，检查密封是否良好。
If table index shafts are loose, tighten mounting bolts.
如果台面索引轴松动，拧紧固定螺栓。
Tighten exhaust manifold to cylinder head bolts.
紧固排气岐管汽缸头螺栓。
Fix and tighten the above-mentioned parts with expansion bolts.
用膨胀螺丝将上述配件拧紧固定。
Starting 180 degrees from last pilot bolt, tighten 3 large bolts all the way (any sequence).
从最后一个导向螺栓开始每隔180度，将3个大螺栓分别拧紧全部行程(按任何顺序)。
After seven days, the grouted mortar will have concreted, then we shall tighten the anchor bolts.
灌浆在七天以后凝固，我们就将拧紧地脚螺栓。
Tighten the engine mount-to-bracket bolts.
拧紧引擎架至支架的螺栓。
Make up and tighten the bolts diagonally when the X-tree is installed.
安装采油树是要对角上紧螺栓。
Unit on the basis of the anchor bolt, after looking for is tighten the anchor bolts.
将机组放在地脚螺栓的基础上，找正后拧紧地脚螺栓。
Therefore, after some measures that changed dimension of the bolts and introducing adhesive to tighten the bolts were carried out, the malfunction could be avoided.
所以采取了改变螺栓尺寸和采用粘接剂进行紧固和防松等措施，使联接螺栓故障现象消除。
When the hydraulic end position together with the back well after the transfer, four bolts to tighten the diagonal way, until a suitable date.
当液力端连同背板位置调好之后，4个螺栓以对角方式拧紧，直到合适为止。
The article discusses how to calculate the torque needed when torque spanner is used to tighten up bolts up to M64, and give the calculating source program and example.
介绍了用力矩扳手上紧M64以下螺栓时，如何计算所需要的力矩，并给出原程序和实例。
Stainless steel screw, hex bolt series: tighten screw, machine screw, nail screw, self-tapping screw, expansion bolts, carriage, lifting eyebolt, a tooth, flat mat, play split cotters cushion etc.
不锈钢螺丝系列：内六角螺栓，紧钉螺钉，机螺钉，自攻钉，马车螺丝，膨胀螺丝，吊环螺丝，牙条，开口销，平垫，弹垫等。
Make sure the power is switched off then tighten up all the bolts on the unit and replace the broken blade.
一定要关掉电源后旋紧所有的螺栓并更换刀片。
Check if there are leakages. If necessary tighten the bolts.
检查是否有泄漏，如果需要，上紧螺栓。
Start pump, and tighten the bolts until leakage is decreased to a tolerable minimum.
启动泵，并上紧螺母直到泄漏量降低至最小允许值。
Start pump, and tighten the bolts until leakage is decreased to a tolerable minimum.
启动泵，并上紧螺母直到泄漏量降低至最小允许值。
应用推荐