With using some simplified heat-transfer & combustion model, the burn-out time and the stay-time(one times through furnace) of a single coal particle in the furnace of CFB were also calculated.
根据流体动力学理论分析了颗粒径与流化速度的关系，通过利用或建立简单的传热与燃烧模型，定量计算了不同粒径无烟煤颗粒的燃尽时间和一次通过炉膛时的停留时间。
The paper introduces a continuous car type furnace for direct reduction of iron ore. Coal-containing iron ore pellets are laid on cars and carried to pass through furnace to be heated and reduced.
介绍一种用于铁矿直接还原的台车连续炉，含碳球团料层铺在台车上并通过炉膛进行焙烧和还原。
We can only go through some fires with a large faith; little faith will fail. We must have the victory in the furnace.
只有大信心才能通过火的试炼，小信必注定失败，让我们争取烈火中的得胜！
The flame in the furnace can be looked at through coloured glasses.
可以通过有色眼镜观看高炉内的火焰。
Only through adjusting power knob on the panel, the power distribution between the two furnace can be achieved.
只需要通过调节面板上的功率旋钮，就可以实现两个炉体之间的功率分配。
The hot air is always carried to the furnace by a powerful turboblower, through the hot blast main, bustle pipe, bootleg, blowpipe and tuyere.
热风由功率强大的鼓风机通过热风总管、环形风管、风口小弯管、直吹管和风口不断鼓人高炉。
Through analyzing the first level load of Isa furnace, this article brings forth an approach to capacity calculation and calibration of diesel-driven generator as well as its environmental correction.
通过对艾萨炉一级负荷的分析，针对柴油发动机和发电机的特性，给出了柴油发电机组容量计算的方法，并根据环境条件对计算结果进行修正。
Through reformation of furnace lines, heating and heat-change way, it is realized to increase output, reduce energy consumption and develop new kinds of product.
宣化泰龙带钢有限公司通过对加热炉的炉型、加热、换热方式进行改造，实现了提高产能、降低能耗、新品种开发等目的，预计半年多可收回成本。
Through orthogonal test, we work out the solution by selecting rational electric regulation and adjusting burden in submerged arc furnace, thus, the production can be operated smoothly.
通过正交实验并选择合适的供电制度及调整矿热炉用料结构等技术措施，找到了解决问题的方法，从而可以使生产正常进行。
This paper provides some suggestions in the management and reducing the accident of water jacket furnace, through analyzing the reasons for the leak of a coil pipe in water jacket furnace.
本文通过对一台水套炉盘管泄漏的原因分析，对油田管理水套炉提供参考建议，对减少水套炉事故有一定的意义。
The concept of furnace combustion management through introduction on line monitoring system with pulverized coal burner was put forward.
通过介绍煤粉燃烧器在线监测系统，提出了炉膛燃烧管理这个概念。
In current through a conductor joule heat generated by the electric furnace for the heat source.
以电流通过导体所产生的焦耳热为热源的电炉。
It has been proved through test that porous honeycomb ceramics could be used as transducer of radiation energy in flame furnace so as to realize the purpose of energy-saving.
通过试验证明，多孔蜂窝陶瓷作为辐射能变换体应用在火焰炉中可实现节能的目的。其原理在于构成蜂窝陶瓷的空腔辐射特性。
Diathermanous furnace inductor, is also know as through-type inductor, it is long or short according to the length of heating workpiece and the diameter of the workpiece.
透热炉感应器，又称贯通式感应器，根据加热工件的长短和工件的直径大小，感应器有长有短。
This paper presents the method for prolonging the life of the frequency-induction furnace through improving furnace making and correct use of the furnace.
介绍了工频感应熔化炉通过改进筑炉和正确使用工频炉来延长炉龄的方法。
Research on mechanism of serious corrosion of furnace lining is conducted; Baiyin furnace life is prolonged through optimized arrangement of refractory material.
对白银炉炉衬蚀损较严重部位的蚀损机理进行了研究，通过采用耐火材料优化配置技术，提高了白银炉寿命。
After compaction the components pass through a sintering furnace.
零件压实后通过烧结炉。
In the first, it is annealed, meaning it is run through a furnace to be softened.
在第一，它是退火，这意味着它是通过一炉运行到软化。
Through a combination of upper and lower engines, the electrode current in the smelting process is controlled to achieve the purpose of controlling the temperature of smelting furnace.
对铅锌矿冶炼厂生产作业进行自动化技术改造，通过上位机与下位机的有机结合，对精矿冶炼过程中的电极电流进行控制，实现熔炉温度控制，解决了传统手法可测不可控的难题。
Activated carbon for electric double layer capacitors was prepared from coal by activation with KOH through heating by microwave radiation and resistance furnace heating.
以煤为原料，KOH为活化剂，采用微波辐射加热法和电阻炉加热法制备出双电层电容器用活性炭。
Experiment on acoustic pyrometry is done using the chirp signal, white noise and sine wave respectively in a 300MW boiler in one domestic power plant, through fire hole on furnace wall.
在国内某电厂的300MW机组锅炉上，利用炉墙上的观火孔，分别用扫频信号、白噪声信号和正弦信号进行了冷态下的声学测温试验。
Through production practice, the maturer experience in operation of large electric furnace is achieved.
经过生产实践，在大型电炉操作运行方面取得了较为成熟的经验。
Through the program debugging, revision, we have finally realized to control the continuous sintering furnace parts transportation.
通过程序调试、修改，最终实现了对连续烧结炉零件输送的控制。
Through reforming original equipment, the synchronous running ration between cleaning system and the furnace is obviously increased.
通过对原设备的改造，使净化系统与电炉同步运行率显著提高。
In this paper, a mathematical model of heat transfer in tube annealing furnace, in which some parameters are confirmed through the embedded thermocouple experiments is presented.
在炉内传热机理研究的基础上，结合实际生产过程中的热电偶实验，建立了钢管光亮退火炉热处理过程数学模型。
The new ones should be inserted smoothly through the hot furnace with sufficient speed to insure that the aluminum is not melted off the terminal end but not so fast as to cause thermal shock.
新的管子迅速的放入管内的发热部以保证铝不会在终端被氧化，如果不那么快的话容易引起热震动。
This paper introduced the technology of increasing propylene yield through optimizing cracking material, adjusting depth of cracking furnace, enhancing operation monitoring of separating system.
通过优化裂解原料，调整裂解炉深度，加强分离系统操作监控，实现增产丙烯。
The blast furnace raceway formation under the intensive coal injection by measurement of micro wave reflection gunned through a tuyere is discussed.
通过利用风口测量枪进行的微波反射测量方法讨论了大煤粉喷吹量条件下高炉风口回旋区的形成。
The blast furnace raceway formation under the intensive coal injection by measurement of micro wave reflection gunned through a tuyere is discussed.
通过利用风口测量枪进行的微波反射测量方法讨论了大煤粉喷吹量条件下高炉风口回旋区的形成。
应用推荐