You must manage the throttle position to climb, descend, or maintain altitude.
你必须管理节气门位置攀登，下降，或保持高度。
Throttle position is changed as vehicle speed changes to keep the car at the desired speed level.
为了保持汽车预想的速度，在汽车速度改变时应调整气门的位置。
At this point, provided the throttle position is sustained, the vehicle will maintain the set speed.
在这一点上，提供了油门的立场是持续的，汽车会保持设定的速度。
The TPS contains potentiometer, connected directly to the throttle Shaft to sense the throttle position.
TPS包含电位计，与节气门轴直接相连，读取节气门位置。
The exhaust valve (5) for engine brake switches the throttle element into an opened position from a throttle position.
排气气门(5)为了发动机制动借助于开到节流位置的节流元件可转换到一暂时打开的位置上。
The author analyzes common ways to inspect the air throttle position sensors of linear variable resistor 'switching and decoding.
对线性可变电阻型、开关型、编码型节气门位置传感器常用的检修方法进行分析和探讨。
If you have a throttle position sensor, you should be able to access the signal from the sensor itself or from the computer connector.
如果你有一个节气门位置传感器，您应该能够访问从传感器从计算机或信号连接器本身。
Analyzing various inputs, such as vehicle speed, engine RPM, throttle position, etc., the TCM decides which gear to shift to and when.
TCM通过分析各种输入信号，例如车速、发动机转速、节气门位置等，来决定何时换入何挡。
This paper introduces the structure and working principles of the throttle position sensor (TPS), emphasizing on its function and inspection method.
阐述节气门位置传感器(TPS)的结构和工作原理，重点介绍节气门位置传感器的功能和检测方法。
Auto-Start function (ATS):A pre-set throttle position, less than full throttle, to be used for the initial acceleration off the line without having wheel spin.
自动启动功能（ATS）：预置一个油门位置（油门不要打满）以用于初始加速，不上线而车轮处于停转状态。
This paper introduced an intelligent eddy current sensor that combined the eddy current technology with the single chip micro-computer for throttle position detection.
本文将电涡流技术和单片微型计算机技术相结合，研制出节气门位置智能电涡流传感器。
Control unite USES extensive 8031 system, sensor system mainly include the Throttle Position sensor, Dissipating Heat Piece Temperature sensor and ignition signal sensor.
控制单元采用扩展的8031系统，传感器主要有节气门传感器、散热片温度传感器和点火信号发生器。
Next is software design of the system, including overall system flow chart, throttle position detection map and the step motor commutation and the point of sub-flow chart.
系统的设计除了硬件还需要软件来支撑，软件设计包括系统整体流程图、油门位置检测图和步进电机换相及角度细分流程图。
The results show that the error of estimated value of both throttle position sensor and manifold pressure sensor are less than 10%, and the strategy put forward in this paper is valid.
结果显示，大部分工况下进气压力传感器和节气门位置传感器的信号重构误差可控制在10%以内，表明了所提出的调节策略是切实有效的。
The switching operation between the two cam lobes is controlled by the ECU which takes account of engine oil pressure, engine temperature, vehicle speed, engine speed and throttle position.
两个凸轮凸角之间的切换系统，是通过ECU对引擎的油压、温度、行驶速度、引擎转速和节油门位置的综合计算，而实现对其的控制的。
One unique feature of this active throttle is that it does not have an engine cutoff position.
这些主动杆的一个统一特征就是它们都没有切断动力的位置。
The author introduces the structure and working principle of this throttle and elaborates the initializing process of the throttle and the accelerator position sensor.
本文介绍电子节气门系统的结构和工作原理，并对电子节气门和加速踏板位置传感器的初始化过程进行说明。
A return switch (RS) is responsive to the motor throttle body, and a pressure sensitive switch (PSS) is responsive to the accelerator pedal position.
返回开关(RS)是顺应电机油门身体，压力感应开关(PSS)的回应是由于油门踏板的位置。
You can yaw or change the throttle while maintaining position.
您可以偏转或改变油门，同时保持位置。
You can see at any moment in a lap speed, throttle / brake position, steering angle and track position.
可以通过微调油门来使重量转移到车头，帮助增加前轮的牵引力，使转向能力增强，修正转向不足。
The result shows that the control system of electronic throttle had good following characteristic and realizes position control of electronic throttle. The system will benefit the automotive...
实验结果表明，该电子节气门控制系统具有良好的跟随特性，实现了节气门系统的位置控制，为提高汽车的动力性、经济性、排放性打下了基础。
Place the mower on a flat surface. Turn the throttle trigger to the "Choke" position.
将割草机放在平坦的表面上，移动油门控制杆调至“手动燃油”的位置。
The mechanical throttle valve is electrically controlled, e. g. the valve position is under closed-loop control to the output of the pressure gauge.
所述机械节流阀受到电控制，例如阀门位置受到根据所述压力表的输出进行的闭环控制。
In Stability Mode, the position of the throttle stick is now relative to the available power output of the motors.
在稳定模式下，油门杆的位置现在是相对于可用功率输出的电动机。
The severity of this braking can be controlled by the throttle stick position in a similar fashion to the reversing speed control.
的严重性，这制动可以控制的油门坚持的立场，在类似的方式向扭转速度控制。
Set the throttle trim to the low (off) position.
油门微调设置到低(关闭)位置。
Set the throttle trim to the low (off) position.
油门微调设置到低(关闭)位置。
应用推荐