You have to push the throttle forward for more power.
你得把油门杆往前推来加大马力。
In the cockpit, I push the throttle forward and pull the yoke back until we fly high enough.
我回到驾驶舱里，开大节流阀加速，将“舵杆”向后拉，直到飞得足够高。
The results show that the error of estimated value of both throttle position sensor and manifold pressure sensor are less than 10%, and the strategy put forward in this paper is valid.
结果显示，大部分工况下进气压力传感器和节气门位置传感器的信号重构误差可控制在10%以内，表明了所提出的调节策略是切实有效的。
As of March 10, Mars will stop retrograding and when it turns direct, it will be time for you to move forward at full throttle.
从三月10日起，火星将会停止倒退而且当它变直接的时候，就你而言，在完整的节流阀向前地移动将会是时间。
Understeer can be remedied by slight modulation in throttle to transfer weight forward to the front wheels, aiding their traction and ability to carve the turn.
可以通过微调油门来使重量转移到车头，帮助增加前轮的牵引力，使转向能力增强，修正转向不足。 收藏。
When the level of the front one-way throttle valve is turned clockwise, the forward traveling speed of the cylinder and charging speed slow down.
顺时针转动前单向节流阀手柄，气缸前行速度放慢，装料速度也放慢。
To cut down the throttle loss, a program to install a small-power Bingham pump is put forward.
为降低节流损失，减少能耗，提出了再增加一台小功率泵的优化运行方案，并对该运行方案进行了具体分析。
When the level of the front one-way throttle valve is turned counterclockwise, the forward traveling speed of the cylinder and charging speed increase.
逆时针转动前单向节流阀手柄，气缸前行速度加快，装料速度也加快。
The authors also put forward control aim of engine speed in the process of vehicle start and shifting, and automatic control to engine speed is realized by adopting electronic throttle.
提出了车辆起步、换档过程中发动机转速控制目标，采用电子节气门进行发动机转速控制，实现了起步、换档时对发动机转速的自动控制。
And then he rolls the plane around, pointing it in the direction he's going down the runway. He then takes the throttle and pushes it forward.
然后他开始让飞机滑行几圈，冲向跑道，他抓住了油门杆猛推向前。
An overly enthusiastic prod of the throttle sends the car leaping forward - holy cow that throttle is so sensitive!
我稍微下踩了一下油门，车子突然猛烈得向前窜了出去，我的老天呀，这车油门也太敏感了吧！
The driller engages the drawworks in forward drive and sets the throttle at minimum speed. And engages the low clutch and slowly spools the drilling line on the drawworks drum.
司钻启动绞车正转，把油门调到最低限度，挂上低速离合器，慢慢的把大绳缠到绞车辊筒上。
Once you reach full on, move the throttle trim forward to confirm that the motor won't go any faster.
当您达到充分就，动议油门修剪着证实，汽车将不会去任何更快。
Once you reach full on, move the throttle trim forward to confirm that the motor won't go any faster.
当您达到充分就，动议油门修剪着证实，汽车将不会去任何更快。
应用推荐