Subarea protection puts overall subarea and thin melt subarea into practice mainly in ancient city area, the subarea having a pertinency controls formation.
分区保护主要在古城区实施整体分区与细化分区，形成具有针对性的分区控制。
The uniformity of thin melt-blown webs which is produced of low melting point copolyamide by melt blowing line with accessory device was tested by weight method.
采用称重法对在添加了辅助装置的熔喷设备上制得的以低熔点共聚酰胺为原料的热熔纤网的均匀性进行了测试。
Indeed, for the Arctic as a whole, the melt season started with even more thin ice than in 2007, hence concerns that we may even beat last year's sea-ice minimum.
确实，把北极看作一个整体，融化季节开始的时候，海冰总量比2007年还要少，因此可能会突破去年海冰量的最低点。
In 2008 and 2009, scientists feared the record-thin Arctic ice cover might melt away.
在2008年和2009年，科学家们担心那个记录——薄北极冰盖可能全部融化。
In addition, he points out that it also means that users can print onto heat-sensitive substrates such as corrugated board and very thin films that can warp, curl or melt due to high heat.
另外，他也指出，这也意味着用户可以在热敏材料基板上打印，例如波纹纸板和一些遇到高温会弯曲，变形的薄膜材料。
Thin wires easily melt if they are made of copper.
如果用铜制细导线极易熔化。
Do not let the consistent adherence to melt into thin air, do not let the pursuit of the holy light dim.
不要让一贯的坚持成为了泡影，不要让追求的圣洁之光暗淡。
A thin surface layer always exists near the surface of laser heating melt pool due to the fluid flow driven by the surface tension gradient.
在激光材料加热中，由于存在着表面张力驱动的流动，熔池表面附近熔体的速度梯度很大。
The factors that affect thin-wall mould warpage, such as mould temperature, melt temperature, rate of injection and holding pressure, etc, are analyzed, in addition the ca…
对影响薄壳塑件翘曲变形的因素（如模具温度、熔体温度、注射速率、保压压力等）进行分析，提出翘曲产生的原因及相应的改进措施。
The structure of pipe is thin inner plastic layer and thick outer plastic layer, easy to join with hot-melt pipe fitting.
生产的管材结构为内塑层薄外塑层厚，以利于与热熔管件连接；
The structure of pipe is thin inner plastic layer and thick outer plastic layer, easy to join with hot-melt pipe fitting.
生产的管材结构为内塑层薄外塑层厚，以利于与热熔管件连接；
应用推荐