The algorithm is able to adjust the schedule to make the strip thickness error less than set one by modifying the limit coefficient of rolling force.
该算法通过调整轧制力限制系数来调整约束条件使得最后道次的出口厚度与目标厚度的偏差小于给定误差，并同时获得优化的轧制规程。
The influence of thickness error of each layer to optical character was also discussed, and the result shows that the most sensitive layer is defect-layer.
同时研究了膜层的误差对滤光片光谱性能的影响，表明其敏感层主要是缺陷层。
The influence of thickness error of each layer to optical character was also discussed, and the result shows that the most sensitive layer is defect-layer.
同时研究了膜层的误差对滤光片光谱性能的影响，表明其敏感层主要是缺陷层。
应用推荐