The results showed that the flow stress of UFG CP-Ti would change significantly with the thermal compression conditions.
结果表明:超细晶工业纯钛在热压缩过程中,热压缩条件不同流动应力变化规律会有所差异。
The application of concentration system with multi - effect thermal compression pump could reduce the consumption of the steam and lower the production cost.
采用多效带压泵的浓缩系统,可大大减少加热蒸汽的消耗量,降低生产成本。
Acording to work principle and heating model of biomass thermal compression, finite model of biomass thermal analysis based on proper hypothesis was formulated.
根据生物质热压成型的工作原理及加热方式,在合理假设的基础上建立了生物质热分析有限元模型。
The present invention relates to thermal compression bonding method for combination pole. First, provide plastic combination base with its combination surface down toward;
本发明涉及一种结合柱的热压合方法,首先提供一塑胶材质的结合座,其中该 结合座的结合面方向是朝下;
A compression process of times compressed, high thermal efficiency.
一个压缩过程分几次压缩,热效率高。
Vapor compression heat pump is a new concept of thermal control system and refrigerator for future space use.
蒸汽压缩热泵是未来大型航天器热控系统和制冷设备的新方案。
Concurrently analyzed is that improvement of effective thermal efficiency after rise in compression ratio and water injection is resulted from thermal efficiency promotion of fuel-air ideal cycle.
同时分析了提高压缩比并掺水蒸气后有效热效率提高的主要来源是燃料—空气理想循环热效率的提高。
The results show that a certain amount of the mixed rare earth oxide content in the batch can increase the cold compression strength and the thermal shock resistance of the bricks.
试验结果表明,在配料中加入适量混合稀土氧化物对提高耐火制品的常温耐压强度和热震稳定性能是有益的。
The fabrication of micro-structures on polymer surfaces has been fulfilled via patterned compression of polyelectrolyte multilayers (PEMs) and thermal pressing method (TPM) respectively.
本文分别利用聚电解质多层膜的压缩和热压技术两种方法构建了聚合物微结构。
The reasons leading to the injury included thermal burn by ultrasound knife in 2 cases and edema compression in 1 case. The injury was transient recurrent laryngeal nerve paralysis.
超声刀热灼伤2例,局部组织水肿压迫伤1例,均为喉返神经暂时性麻痹。
Homogenous Charge Compression Ignition (HCCI) combustion technology is receiving increased attention for its ultra-low NOx and PM emissions and high thermal efficiency.
均质压燃(HCCI)燃烧技术以其低氮氧化物、低微粒排放和高热效率的优点而引起世界各国的广泛关注。
The thermal imaging theory and the characteristics of infrared image are analyzed in this dissertation. Based on it, a number of theoretic algorithms of infrared image compression coding are explored.
本文结合热成像技术原理对红外热图像的特征进行了分析,并在此基础上去探索红外图像压缩编码的理论算法。
The thermal residual stress gives rise to the differences between tension and compression behaviors of the composites.
同时。热残余应力是导致复合材料拉、压机械性能不同的主要原因。
The passive crossover network features a thermal protection system on the HF section providing audibly transparent protection for the compression driver.
被动分频网络功能,对热防护系统高频部分提供出声透明的压缩驱动程序的保护。
The thermal insulation material of industrial kiln, with a higher compression strength and a lower thermal conductivity, is made mainly from stone coal cinder.
以石煤渣为主要原料研制的工业窑炉保温材料,具有较高的耐压强度和较低的导热率。
The design of thermal -compression - pump in multi -effect evaporator was discussed.
本文拟对三效蒸发器的热压泵进行探讨、设计。
A compression process of times compressed, high thermal efficiency. 3 no suction and discharge valves, the intake and exhaust resistance loss is almost zero.
一个压缩过程分几次压缩,热效率高。3无吸、排气阀,故进、排气的阻力损失几乎为零。
A higher octane level also allows for higher compression ratios and improved thermal efficiency.
一个高辛烷值水平也允许更高的压缩比和提高热效率。
When compression ratio is increased, the volumetric efficiency is increased, giving a fast burning rate and thus high thermal efficiency and power output.
压缩比增加,发动机充量系数增加,燃烧速率加快,热效率提高。
The application cost of glass wool increased because of the additional compression resistance layer, and the thermal insulation performance of common greenhouse was the worst.
玻璃棉由于附加抗压层而导致应用成本提高,常规材料干草帘的保温性最差。
Therefore the wicks cater to two performances of the high thermal conductivity and the compression bending of the heat pipe, and improve the application of the heat pipe.
所以此方法制备的芯体材料能够兼顾热管高导热率和弯曲加工的两项性能,提高了热管应用的平台。
Therefore the wicks cater to two performances of the high thermal conductivity and the compression bending of the heat pipe, and improve the application of the heat pipe.
所以此方法制备的芯体材料能够兼顾热管高导热率和弯曲加工的两项性能,提高了热管应用的平台。
应用推荐