This investigation material supplies reliable evidence for the theory of the systemic membrane defect of DMD.
本研究结果为DMD的全面性膜缺陷理论提供了可靠的证据。
Based on the geometrical nonlinear finite element (GNFE) theory, a curved quadrilateral isoperimetric element with 8 nodes for initial form analysis of tensile membrane structures is presented.
本文根据几何非线性有限元理论，提出张力膜结构初始形态分析的8结点曲面四边形等参单元。
First, the fundamental equations of flat membrane structures are obtained by applying the non-moment theory of thin shallow shells.
首先，利用扁壳的无矩理论得到了平坦薄膜结构的基本力学方程。
For stress analysis we have adopted the membrane theory of spherical shells.
我们采用球壳无矩理论来进行应力分析。
With the total strain theory and membrane assumption and taking the normal anisotropy of sheet metal into consideration, initial blank size can be directly calculated from desired flanging height.
在该算法中，采用了全量塑性理论及膜应变假定，并考虑了板材的厚向各向异性，可以直接从所需的翻边高度计算出初始坯料的尺寸。
A formula about cellular pressure produced by the electricity on the plant cell membrane was deduced by the double electrical layer model of cell membrane and electrical theory.
根据细胞双电层模型和电学原理，推出了圆筒型植物细胞膜上电荷产生的细胞内压力的计算公式。
Based on Membrane Bioreactor performance, this article introduces the newest wastewater treatment theory and technology of no excess sludge production.
本文介绍了以膜生物反应器为基础的剩余污泥产量最少或无剩余污泥产生的最新的污水处理理论和技术。
Then an analytical model for axisymmetric case is developed based on the total strain theory and membrane assumption.
基于全量塑性理论及膜应变假定，推导了轴对称情况的解析计算模型；
So a more integrated technological theory for balance of membrane flux is discussed.
从而为平衡膜通量问题提出了一套较为完整的工艺理论。
In this paper, the problem of large axisymmetric deformation of hyperelastic membrane is reformulated on the basis of the general theory of finite elasticity.
本文从有限弹性理论出发对超弹性薄膜轴对称大变形问题进行了一般的数学描述。
At present, certain achievement of the research in the theory and practice to the Cable-Strut-Membrane Structure has made both at home and abroad.
目前，国内外对索杆膜结构的研究在理论和实践均取得了一定的成果。
The morphological change and its formation mechanism of polymer membrane system induced by nanoparticle inclusions are investigated by self-consistent field theory.
利用自洽场方法对含有纳米嵌入物的聚合物膜的形貌变化及其形成机理进行了系统的理论研究。
Based on geometrical nonlinear finite element theory, a curved quadrilateral isoperimetric element with 8 nodes for initial form analysis of tensile membrane structures is presented.
根据几何非线性有限元理论，提出张力膜结构初始形态分析的8结点曲面四边形等参单元。
The free radical theory of aging indicates that the effect of membrane damage produced by free radicals and lipids peroxidation is one of the major reasons of aging.
衰老的自由基学说认为，自由基及其诱导的脂质过氧化对生物膜的损害作用是衰老发生的主要原因之一。
Nitrogen-production equipment, in accordance with molecule movement theory, is to separate and enrich nitrogen from air, and hollow fiber membrane is the key.
制氮设备依靠分子运动理论，由空气中分离富集氮气，中空纤维膜是其关键技术所在。
Based on the geometrical nonlinear theory, the equations for form finding of cable nets and membrane structures are established.
在几何非线性有限元理论的基础上，建立了膜结构和索网结构非线性位移法找形分析的基本方程。
According to the theory of a plate with large deflections, the motion responses equations of a floating plate are established considering the influence of the membrane forces.
根据板的大挠度理论，考虑板内的薄膜力，建立了波浪中运动平板的水弹性运动方程。
In comparison with the membrane theory, we proved that approximate computation by the membrane theory was adapted for engineering computations and the error in this case is not more than 5%.
比较了有矩理论和无矩理论解之后，指出：在工程实用中可用无矩理论近似求解，误差不大于5%。
Wrinkling characteristics of a conical inflated cantilever beam under bending is analyzed based upon the membrane theory.
该文基于薄膜理论分析了受弯充气锥台的褶皱特性。
The relation between the interfacial liquid membrane (ILM) technology and the theory of similitude were discussed.
讨论了界面液膜(ilm)技术和相似理论之间的关系。
Since normal plastic theory is too complex, the membrane theory and the semi-membrane theory are adopted to establish the equilibrlm equations in plastic limit analysis.
鉴于有矩理论的复杂性，本文在作极限分析时，采用了无矩理论和半无矩理论的平衡方程分别作为中短壳和长壳的平衡方程。
As to the primary B-CS, there are congenital membrane theory and acquired thrombosis theory to illustrate the cause.
对于原发性B - CS的病因又有先天性隔膜形成学说和后天性血栓形成学说。
Based on the theory of generalized conforming element, two triangular membrane elements with rotational degree of freedom are developed by introducing internal parameters into its displacement field.
应用广义协调元理论，通过增加内参位移的方法，构造了两个具有旋转自由度的三角形膜元。
Regarding the wrinkle analysis of the membrane structures, some studies have been conducted to date, most of which are based on the Tension field theory.
目前采用的膜结构褶皱分析方法大多以张力场理论为基础。
Based on geometrical nonlinear finite element theory, a curved quadrilateral isoperimetric element with 8 nodes for initial form analysis of tensile membrane structures is presented.
本文根据几何非线性有限元理论，提出张力膜结构初始形态分析的8结点曲面四边形等参单元。
Based on the geometrical nonlinear finite element (GNFE) theory, a curved quadrilateral isoperimetric element with 8 nodes for initial form analysis of tensile membrane structures is presented.
根据几何非线性有限元理论，提出张力膜结构初始形态分析的8结点曲面四边形等参单元。
In this paper, the relative theory and its corresponding finite element calculation formula about the shape finding of membrane structure is introduced.
介绍了利用非线性有限元法进行薄膜结构找形分析的相关理论和相应的有限元计算公式。
Based on the theory of stability, a numerical analysis method of the membrane wrinkle is established, and the results are certified by experiments.
基于稳定性理论建立了薄膜褶皱的数值分析方法，通过实验的方法对分析结果进行了验证。
This paper expounded techniques and technical pressing and theory of membrane form pressing for mod - ern furniture, also requests of materials and technical parameters.
论述了现代家具型面部件的模压原理、工艺流程、模压对所用各种原材料的要求以及真空模压家具型面部件的技术参数。
Based on geometrical nonlinear finite element theory, a curved quadrilateral isoperimetric element with8 nodes for initial form analysis of tensile membrane structures is presented.
根据几何非线性有限元理论，提出张力膜结构初始形态分析的8结点曲面四边形等参单元。
应用推荐