The gauge showed that the steam temperature was normal.
仪表显示蒸汽温度正常。
Main factors influencing boiler steam temperature in power plant were described in this paper. And it points out methods to adjust the steam temperature.
叙述了发电厂影响锅炉汽温的主要因素，提出了调整汽温的措施。
This paper introduces the steam temperature deviation in the superheater system of 600mw tangential firing boiler and also introduces the reasons to cause these steam temperature deviations.
阐述了四角切向燃烧600MW锅炉过热器系统蒸汽温度分布特性，分析了这种温度分布特性产生的原因，并提出了解决过热器系统存在的蒸汽温度偏差的措施。
The paper describes the modeling and adaptive control of a superheater. Digital simulation shows the feasibility of the adaptive controller for the steam temperature control of a superheater.
本文用多种方法建立了热电厂过热器的数学模型，还设计了过热蒸汽温度的适应控制器。仿真结果表明，用适应控制器控制过热蒸汽温度是可行的。
The water engine will use steam, created by solar panels (太阳能板) that heat water to a high temperature.
这种水力发动机可以利用太阳能板将水加热至高温从而产生的蒸汽。
The temperature of the steam produced varies, depending on how hot the source is and how much heat it loses on its way to the surface.
产生的蒸汽温度不一，这取决于热源的温度以及通向地表过程中损失的热量。
A robot that previously entered the building measured the humidity and temperature at about the same as that of a steam bath or sauna.
之前曾经有一个机器人进入厂房，检测出里面的湿度和温度相当于桑拿蒸气浴。
The fact that we have a solar plant producing the highest quality, highest temperature, highest pressure steam anywhere in the world is the most important thing.
最重要的是我们的太阳能电站能生产最高质、最高温、最高压的蒸汽。
The temperature is so high as to change water into steam.
温度是如此的高，以至于水都变成了水蒸气。
After cooler out at the exit of compressed air temperature should be saturated steam, and air temperature should be pressure of compressed air condensation point.
后冷却器出来的压缩空气在其出口温度下应该是水蒸气饱和的，且气流温度应该是压缩空气的压力凝露点。
The exergy loss of primary steam after temperature and pressure reduction is calculated.
计算了一次蒸汽经减温减压后的火用损失。
For high efficiency, the steam must decrease substantially in temperature as it expands within the engine.
蒸汽在发动机中膨胀后，温度必须大幅度地下降以获得高效率。
The fast cooling technology of steam turbine is the process that the cooling medium is used to accelerate the temperature reduction of cylinder and rotor after the shutdown of turbogenerator.
汽轮机快速冷却技术是在汽轮机组停运后，向汽轮机内部通以适量的较低温度的冷却介质，进行强迫对流换热，加快汽缸和转子温降速度的过程。
To the embrittlement phenomenon of steam turbine rotor, this thesis calculated 300mw steam turbine rotor's transient temperature field of cold start-up using FEA method.
本文针对汽轮机转子的脆化现象，运用有限元方法对引进型300MW汽轮机冷态启动过程的高中压转子瞬态温度场进行了分析计算。
The boot after the refrigerant compressed by the compressor from low temperature to high temperature and high pressure steam.
开机后冷媒经压缩机压缩由原来的低温低压状态变成高温高压的蒸气。
Steam is superheated by being heated above the temperature of saturated steam.
蒸汽被加热到饱和蒸汽的温度以上使之过热。
The FDA has no written position addressing rouging, its existence, or presence in high temperature high purity water clean steam systems.
FDA还没有书面讨论生锈及其存在方式，或在高温高纯水清洁系统中的存在。
The superheated steam temperature is an important parameter in the waste heat recovery system of sulfur-based sulfuric acid plant.
硫磺制酸装置余热回收系统的过热蒸汽温度是一个重要的参数。
The maximum steam load produced by the bark was determined by the bark fixed combustion temperature and the capacity of attemperator system when the basic steam load was given.
在一定的基本蒸汽负荷下，燃树皮产汽负荷的上限值可根据流化床中树皮的稳定燃烧温度和减温系统的工作能力来确定。
The paper expounds the controlling methods of steam maintenance temperature for beam slab precasting.
就如何控制梁板预制的蒸气养护温度进行了阐述。
The difference in temperature of time of good weather, daytime and evening will become big, meeting the steam of cold air, change into small drop of water.
天气好的时候，白天与晚上的温差就会变大，遇到冷空气的水蒸气，就变为小水滴。
The changes of steam pressure and temperature canont influence the trap. It sas good working characteristic.
该阀不受蒸汽压力、温度变化的影响，具有良好的工作特性。
The major factors for the erosion corrosion of the steam ejection pump in the decarbonization system were media temperature, electrolyte and depolarization of oxygen in addition to flow velocity.
介绍了脱碳系统蒸汽喷射泵的冲刷腐蚀情况除流速外，介质温度高、含有电解质和氧的去极化作用是产生腐蚀的重要因素。
The drop in temperature condensed the steam to water.
温度下降使蒸汽凝成了水。
The results indicated that the shape of steam plume was influenced by the inlet steam pressure and subcooled water temperature.
结果表明入口蒸汽压力和过冷水温度是影响汽羽形状的主要因素。
We know that the superheated steam temperature of boiler superheated system in the fired power plant has nonlinear, uncertain, large time-delay and large inertial characteristics.
我们知道，火电厂锅炉高温过热器的过热汽温是一类非线性、时变大、大时滞、大惯性的典型对象。
The primary factors are filter cake moisture content, impurity content in cake, purge gas flow, residence time, holdup volume, the distance among steam tubes and the temperature of heater plate.
滤饼含湿量、滤饼中杂质含量、吹扫气流量、停留时间、滞留体积、出料旋转阀能力、蒸汽列管间距和加热板温度等。
This Pressure is determined by the temperature of saturated steam at the maximum temperature shown.
这个压力取决于饱和蒸气在表中的最高温度。
This Pressure is determined by the temperature of saturated steam at the maximum temperature shown.
这个压力取决于饱和蒸气在表中的最高温度。
应用推荐