This paper studied the three-phase PWM(pulse width modulation) rectifier in dual PWM variable frequency speed regulation system.
对双PWM变频调速系统中的三相PWM整流器及其控制方法进行了研究。
MW DC arc furnace uses the current 2-transformer rectifier bridge thyristor controlled by adjusting the angle trigger to compose 24 pulse wave rectifier circuit.
MW直流电弧的电流控制采用2台整流变压器控制，通过调节晶闸管桥触发角构成24脉波整流电路。
Aiming at the complicated design of three-phase PWM (Pulse Width Modulation) rectifier by using nonlinear feedback method, a linear feedback approach based on inverse system method is presented.
针对三相脉宽调制(PWM)整流器控制采用非线性反馈方法使控制器设计复杂化的问题，提出一种基于逆系统方法的三相pwm整流器的反馈线性化控制方法。
Through analysis of the current waveform of the semi-control double three-phase 12-pulse rectifier and the expansion of Fourier series, the main harmonic components of the system were obtained.
通过对半控双三相12脉冲整流器的电流波形分析和傅立叶级数展开，得出系统的主要谐波成分。
Single phase voltage pulse rectifier is an important part of the traction system.
单相电压型脉冲整流器是牵引传动系统的一个重要组成环节。
Compared to the traditional topology of multi-pulse rectifier, the rectifier realizes a lower THD, which is less than 5% required by the power system, and its power factor is above 0.
提出一种新的复合型整流器拓扑结构，该整流器与传统的多重化整流器相比，其THD达到了电力系统小于5%的要求，功率因数在0。
The measuring system consists of a pulse amplifier, a rectifier, an integrator, and a pulse counter.
自光电倍增管而下测量系统由脉冲放大、整流、积分和计数器等组成。
A digital pulse generator for a silicon controlled rectifier and digital PID algorithm for some industrial process control are realized by the microcontroller.
实现了数字化可控硅变流器的脉冲控制及一般工业控制过程的PID数字算法。
This paper studies the fault classification and diagnosis method of the double-bridge 12-pulse waveform controlled rectifier circuit based on pattern recognition.
研究了一种双桥并联可控整流电路的故障分类及诊断方法。
The 24-pulse rectifier based on autotransformer scheme is proposed in the paper.
接着本文提出了一种基于自耦变压器的24相整流电路。
The voltage is changed by varying trigger angle of the rectifier , pulse distribution implemented by software, and all control conducted on computer TP 801 so as to fully digitalize the whole system.
随后采用可控硅整流加滤波的电路对步进电机供电，用改变可控硅触发角的大小来改变供电电压，并用软件实现步进步机的脉冲分配，全部控制用单板机来实现，使整个系统完全数字化。
AC network with DC network are also combined in a AC-DC iterative power flow calculation program through the detailed model of 24-pulse bridge rectifier.
通过对24脉波换流站进行精确建模，将换流站两侧的直流网络和交流网络联系起来，运用交直流潮流迭代计算的方法计算地铁供电网络的潮流分布。
AC network with DC network are also combined in a AC-DC iterative power flow calculation program through the detailed model of 24-pulse bridge rectifier.
通过对24脉波换流站进行精确建模，将换流站两侧的直流网络和交流网络联系起来，运用交直流潮流迭代计算的方法计算地铁供电网络的潮流分布。
应用推荐