And the productivity model was tested and analysed.
并对生产率模型进行了验证与分析。
Bonded and unbonded prestressed concrete frames are tested and analysed up to failure.
本文进行了有粘结和无粘结预应力混凝土框架的反复荷载试验。
The mechanical properties of concrete filled steel tube coloums with holes reinforced were tested and analysed.
对某高层建筑结构开洞补强钢管混凝土柱轴心受压的力学性能进行了试验研究和分析。
By using high - speed camera and image analyzer, camel locomotion characteristics on slope were tested and analysed.
利用高速摄影系统和图像处理仪测试和分析了骆驼的的坡道运动特性。
Finally, three-dimensional consolidation characteristics of structural loess is tested and analysed in the condition of true triaxial test.
最后,在真三轴试验条件下测试分析了结构性黄土的三维固结变形特性。
The stability and composition of oxidic film and the C-V characteristics of MOS structure have also been tested and analysed theoretically in this paper.
对氧化膜的组分和稳定性,以及MOS结构的C—V特性进行了实际测量和理论分析。
The dynamic viscoelasticity has been tested and analysed for two kinds of raw cocoons with good and bad reelabilities under different cocoon cooking process conditions.
指出了有关文章所采用的煮熟茧动态粘弹性参数的一些问题,并提出了合理选用参数的方法。
This paper introduced a method of making ceramic film using the physical vacuum deposition and it also tested and analysed its physical feature, and got some useful conclusion.
本文应用真空物理淀积方法制备了铬酸锌湿敏陶瓷簿膜元件,并测量和分析了其物理特性,得出了一些有益的结论。
Knowledge can be tested, climate change identified, stock markets analysed and the very origins of the universe probed.
人们可以验证知识、确认气候变化、分析股票市场、探索宇宙起源。
The equation is tested by the T106 grid data of September in 1996. At the meantime, prediction abilities of the method and T106 products are analysed in temperature forecast.
并用1996年9月份T106格点资料对方法进行检验,同时对预报方法及T106产品在温度预报中的释用能力作了初步分析。
Using this method and plan, we have analysed and tested WNS4-8 boiler.
并用此方法和方案对WNS4—8型火管锅炉完成了分析和试验。
In this paper, the viscosity, adhesion force and film properties of the acetate starches size are tested, and the test results are analysed.
本文对醋酸酯淀粉浆液的粘度、粘着力及浆膜性能进行了测试,并对测试结果进行了分析。
The plating baths with different orthophosphate content were analysed, and the corresponding coating characteristic was tested.
对正磷酸根含量不同的镀液进行了分析,并测试了相应镀层的性能。
The correlation between discharge coefficient and lift was tested for three typical safety valves, and the experimental results were analysed and discussed in this paper.
本文对三种典型结构的安全阀进行了排量系数与开启高度关系的试验,并对试验结果进行了分析和讨论。
Raw materials selection, in manufacturing process, film forming characteristics and key operations were analysed and discussed, properties of the products obtained were tested.
分析讨论了生产过程中的原料选择、成膜特点及施工要点,测试了所得产物性能。
Methods The cell growth was tested by trypan blue stain assay and the cell cycle was analysed by flow cytometry in the various conditions.
分别采用台盘蓝拒染法及流式细胞术,在不同条件下测定细胞增殖的抑制率及细胞周期的分布。
Methods The level of S-Hg of 16 specimens on each time-point before or after amalgams filling were tested by means of absorbed spectrometry, and analysed by SAS program.
方法用冷原子吸收光谱法测定16名实验对象银汞合金充填前和充填后各时间点唾液汞量,用SAS软件程序进行分析统计。
Also the PTC materials microstructure was characterized, and its samples property was tested, and the technology factors, the additives so on was analysed.
对其微观组织及性能进行了测试和表征,并对添加剂、试验工艺等影响因素进行了分析。
We analysed an old wastewater treatment process of a phosphor factory, and tested biochemical treatment and chemical treatment. At last, we obtained some efficient results.
对彩虹荧光粉厂原废水处理方案进行了分析,通过化学方法和生化法对其进行了改进试验,得出了非常满意的处理效果。
Methods The titanium porous surfaced implant was made by plasma spray with ti powder. It's ti coated porous surfaced was observed analysed and tested.
方法选用等离子喷涂方法,将纯钛粉喷涂到纯钛桩表面,形成表面多孔种植体,并对涂层成份进行分析,力学测试粘接强度及扫描电镜观察表面形态。
The mechanical property of weld joint was tested and the microstructure was analysed, the welding process was proved feasible.
通过对焊接接头的力学性能检验、微观组织观察和分析,证明了该焊接工艺的可行性。
In the paper, we analysed theoretically the feasibility of nonionic surfactant being used as additives of chemical peeling solution and we tested and verified all the analysis with experiment.
本文从理论上分析了非离子表面活性剂作为化学脱皮液添加剂的可行性,并通过实验验证了这些分析。
The economy and the practicality of different floor framing systems were analysed and compared in detail, and the construction effect of the prestressed floor was tested in situ.
文中着重对不同钢筋混凝土楼盖布置方案的经济性和实际应用效果进行了分析对比,并介绍了对楼盖预应力的施加效果进行的现场测试工作。
They analysed mineral constituents of the clinker by XRD and tested press strength of the specimen made with the cement paste.
利用XRD分析其熟料矿物组成并制成净浆试体测其强度。
The causes of fracture of the chipper knives made in China are analysed. A new process on gaseous Carbon-Nitrogen-Boron penetration is tested and better results have been achieved.
分析了国产削片刀失效的原因,试验了气相碳-氮-硼共渗新工艺,为提高国产刀片质量提供了必要的科学依据。
The water in fertilizer by vacuum oven method were tested, and sources of uncertainty measurement of water were analysed and evaluated.
利用真空烘箱重量法测定了复混肥料中的水分,并对水分的测量不确定度的来源进行了分析和评定。
The stress corrosion and intercrystalline corrosion of 690TT alloy are tested in the article. Besides it's organization and fracture etc are also analysed.
对690TT合金的应力腐蚀和晶间腐蚀进行了试验,另外对其组织及断口等也进行了分析。
Its dynamic performance has been tested through the experiments and analysed the related results.
通过试验研究其主要力学性能,并对试验结果加以分析。
A new method of current measurement is discussed in the paper. The fundamental is analysed theoretically and tested.
本文讨论了一种新的电流检测方法,对其原理进行了理论分析及实验验证。
A new method of current measurement is discussed in the paper. The fundamental is analysed theoretically and tested.
本文讨论了一种新的电流检测方法,对其原理进行了理论分析及实验验证。
应用推荐