FT-B torque meter is composed of high-accuracy tension-compression type sensor and digital display.
发动机测试仪表——FT-B型转矩仪中是由高精度拉压传感器和数字显示仪表组成。
Drill string receives the complicated stress which is tension-compression stress, torsion stress, bending stress, etc.
在长期工作中，钻具承受拉伸、压缩、弯曲和扭转等复杂应力。
Using the tension-compression sensor as a measuring element of torque, the measuring, precision of dynamometer was raised.
采用拉压力传感器作为扭矩测量元件，提高了测功器的测量精度。
A kind of method to evaluate and test the tension-compression fatigue strength of gray cast iron was introduced in this paper.
介绍了一种评价与测试灰铸铁铸件的拉压疲劳极限的方法。
Because of the polarity of tension twining, the tension-compression asymmetry of AZ31B magnesium alloy is much pronounced when tested along extruding direction.
由于拉伸孪晶只能单向启动，AZ31B镁合金在挤压方向的动态拉压不对称性显著。
The proof strength can be used to evaluate the tension-compression fatigue strength of gray cast iron, and also used as the stress level of the tension-compression fatigue test.
利用引伸计拉力试验中的规定总延伸强度可以评价灰铸铁的拉压疲劳极限，也可以利用该数值作为预计的疲劳极限，用于拉压疲劳试验应力水平的选取。
Tension-compression alternating regions can be formed around the rock mass during excavation process. The zonal disintegration phenomena may be brought when the geostress is too large.
地下工程开挖过程中，在洞室围岩中会产生拉压交替变化区，当地应力过大时，会产生分区破裂化现象。
On this basis, the failure criterion of concrete simultaneously considering the freeze-thaw cycle and tension-compression ratio in principle stress space and octahedral space is established.
在此基础上，分析了双轴拉-压极限强度随冻融循环次数的变化规律，并在主应力空间和八面体应力空间建立了同时考虑冻融循环次数和拉压比的破坏准则。
The two data correspond to uniaxial compression and tension, respectively.
两个数据对应单轴压缩和张力，分别。
When stainless steel is bent, the metal towards the outside of the bend is in tension and the metal towards the inside is in compression.
当不锈钢弯曲时，朝向弯曲外面的不锈钢被拉紧，朝向弯曲内面的不锈钢被压缩。
Basically plain masonry is walling material, strong in compression and relatively weak in tension.
基本上简单的石工正在墙壁材料，强壮的在压缩中和相对地弱的在紧张方面。
And even better, it is not only strong in tension but also in compression.
甚至更好，这不仅是强大的张力，而且在压缩。
Adverse condition of concrete in tension and steel joist in compression occurs at inner support regions of continuous composite steel concrete beams.
连续组合梁在内支座处的负弯矩区段会出现混凝土板受拉、钢梁受压的不利局面。
Subsequent application of tension or compression, depending on packer design, will set the packer elements.
随后施加拉张力或压缩力(取决于封隔器的设计)使封隔器密封元件坐封。
It is shown that, when the effect of warping on rotation Angle is neglected, tension (or compression) is only coupled with horizontal bending and vertical bending instead of constrained torsion.
所得到的刚度矩阵表明，只有当忽略翘曲变形对截面转角的影响时，轴向拉压才只与水平弯曲及竖向弯曲相耦合，而与约束扭转不再耦合。
This paper describes the failure mechanisms based on shear, compression, tension and flexure, analyzes characteristics and problems of those models and then discusses the future trend.
本文介绍纺织结构复合材料在剪切、压缩、拉伸和弯曲情况下的破坏机理，分析其特点和存在的问题，提出了发展趋向。
Measurements have been made to determine the relation of the tension, the compression and the shearing of PUR foam at low temperature with its density, direction and temperature.
测定了低温下聚氨酯硬泡沫塑料拉伸、剪切和压缩弹性模量与泡沫密度、方向以及温度的关系。
So, such biomechanical experiments as compression rigidity, tension rigidity, torsion rigidity, bending rigidity were carried out, and the steadiness of different fixation methods was observed.
对所有标本进行压缩刚度，拉伸刚度，扭矩刚度，弯曲刚度等生物力学实验，观察不同固定方法的稳定性。
By using molecular dynamics(MD) method, the axial tension and compression of the (10,10) carbon, BN nanotubes and nanopeapods were simulated.
采用分子动力学方法，模拟了（10，10）碳、氮化硼纳米管及纳米豆荚的轴向拉伸与压缩。
The thermal residual stress gives rise to the differences between tension and compression behaviors of the composites.
同时。热残余应力是导致复合材料拉、压机械性能不同的主要原因。
Because of the different properties when concrete is tensed and compressed, the translation relation of the tension damage and compression damage has been studied.
由于混凝土材料的拉、压性质不同，所以也进行了与定量分析有关的混凝土拉、压损伤定量转换关系的研究。
The calculating method, optimum strengthening design and application of axial tension and compression members strengthened by prestressing is analyzed and discussed.
分析和研究了预应力加固轴心受拉和轴心受压构件的计算方法、优化加固设计及其应用。
The results indicate that the rheological models of glass are different in tension and compression, so that the above assumption is not reasonable.
实验结果表明：玻璃在拉伸和压缩状态下的流变模型存在差异。因此，假定玻璃在拉、压状态下的流变模型相同是不合理的。
Stress results from forces such as tension, compression, or shear that pull, push, twist, cut, or in some way deform or change the shape of a piece of material.
压力产生于拉伸，压缩，或者拖，推，扭，削之类的剪切，或者某种变形以及材料的部分形状改变。
The tension and compression ultimate strengths of femur and tibia were tested, too.
还测试了股骨、胫骨拉伸和压缩时的破坏强度。
The experimental results of steel bar tension strain and concrete compression strain are given.
给出了钢筋拉应变、混凝土压应变的试验结果。
So far, we have found that the static elastic modulus of wood can only be measured through the experiments of tension, compression and bending.
到目前为止，仅通过拉伸、压缩或弯曲试验测得了木材的静弹性模量。
This apparatus can be used to measure the properties of materials subjected to tension, compression and torsion separately.
该装置可分别进行材料的拉伸、压缩、扭转性能测试。
This apparatus can be used to measure the properties of materials subjected to tension, compression and torsion separately.
该装置可分别进行材料的拉伸、压缩、扭转性能测试。
应用推荐