Nano-powder of lanthanum chromites were synthesized by low-temperature combustion method.
用低温燃烧合成法合成了铬酸镧纳米粉体。
However, under high temperature combustion conditions, gas radiation is very important in the total heat transfer.
然而在高温燃烧环境下，气体辐射在总的热量传递中占有不可忽略的比重。
The high temperature combustion desulfurization possibility by fly ash remelting is study in vertical experiment cyclone furnace.
通过立式旋风炉实验台研究以飞灰重溶的方法解决高温燃烧固硫问题的可行性。
Circulating fluid bed boiler is low temperature combustion, the flame features of which are much worse than that of pulverized coal boiler.
循环流化床锅炉属于低温燃烧，它的火焰特征与煤粉炉完全不同。
The technology of blast furnace gas low temperature combustion and pipe still energy-saving and discharge reduction was studied in the paper.
本文对高炉煤气低温燃烧和管式炉节能减排技术进行了研究。
With low temperature combustion in each section, the discharge amount of SO2 is lowered greatly and nice effect of environmental protection is achieved.
采用分段低温燃烧，大幅降低SO2排放量，可达到良好的环保效果。
Multi phase PSZ micro_powders were prepared by low temperature combustion synthesis (LCS) method, with which nitrates were used as oxidizers while urea as fuels.
用水合硝酸盐作氧化剂、以尿素为燃料 ，根据推进化学计算原料的配比 ，进行了复相PSZ超细陶瓷粉的低温燃烧合成 。
The high temperature combustion of the water by high-temperature catalytic oxidation, so that the organic compounds and inorganic carbonate were converted into carbon dioxide.
经高温燃烧管的水样受高温催化氧化，使在有机化合物和无机碳酸盐均转化为二氧化碳。
Infrared sensitive material CaS:Eu, Sm was synthesized by adding sublimate sulphur and using nitrate-urea as raw material system in a low-temperature combustion synthesis(LCS)method.
以金属硝酸盐-尿素作为原料体系，引入了升华硫粉，通过低温燃烧法一步合成了硫化物体系红外响应材料。
Using fractal theory as a theoretical tool, the changes of surface morphology of coal chars of four types of coal during low temperature combustion were studied by nitrogen adsorption.
以分形几何为理论工具，采用低温氮气吸附法，对四种煤在低温燃烧过程中表面形态变化作了考察。
The thermal fatigue resistance high temperature combustion gases of eight heat resistant steels and superalloys in fatigue properties were studied on test rigs heated by combustion flue gas.
对选作高速柴油机预燃室喷咀材料的八种耐热钢及高温合金的燃气热疲劳性能进行了试验研究。
The study also shows that the ignition and combustion of boron particle lie on the resorting time and the environment temperature, and have no direct relationship with after-burning chamber's length.
研究还发现，硼颗粒的点火燃烧主要取决于硼颗粒在补燃室内的滞留时间和所处的环境温度，而与补燃室的长度没有直接关系。
The nozzle spray characteristics of micro-turbine engines affect the stabilization of flame of the combustion chamber, the distribution of temperature, and the efficiency of combustion.
针对微型燃气涡轮发动机喷嘴的雾化对燃烧室火焰稳定性、温度分布和燃烧效率的影响。
The experimental results indicate that secondary air can accelerate volatile combustion in dilute phase zone and raise temperature here remarkably.
实验结果表明：二次风可以促进挥发分在稀相区的燃烧，对提升稀相区的温度作用明显；
The operational principle of the combustion efficiency meter and the basic circuits for thermocouple temperature measurement, oxygen measurement, co measurement are introduced.
介绍燃烧效率测定仪的工作原理及热电偶测温、氧测量、一氧化碳测量的基本电路。
Regenerators, which recover waste heat and provide high temperature air, are key components of the regenerative high temperature air combustion system.
蓄热室是蓄热式高温空气燃烧系统实现余热回收和获得高温空气的关键部件。
An ignition stability index for pulverized coal (CI) has been contrived with IG-DTG analysis data. It comprehensively reflects the pulverized coal's ignition temperature and its combustion intensity.
利用热分析(TG - DTG)数据建立了煤粉着火稳定性指数CI，它是煤粉着火温度与燃烧强度的综合反映。
With the constantly increasing of output of engines and the more stringent exhaust emission regulations, it is necessary to measure the combustion flame temperature of the engines.
在发动机的不断强化和对排放日益严格的限制下，有必要对燃烧过程的火焰温度进行测试。
For HTAC (Hight Temperature Air combustion) technology, pressure control and pressure fluctuation during combustion switchover are very important to the furnace reliability and stability.
蓄热式燃烧技术中，炉压控制和换向时造成的炉压波动是一个非常重要的问题。
Combustion at high temperature causes decomposition to nitrogen and water.
氨在高温下燃烧分解成为氮和水。
Simply put, the general building materials (such as wood, gypsum board to the metal ceiling) when subjected to high temperature or combustion will spread the fire and heat to other locations.
简单地说，一般建材(如木材、石膏板其至金属天花)当受到高温或燃烧后都会将火和热蔓延至其它位置。
Conduct the ignition in a well-ventilated hood, but protected from air currents, and at as low a temperature as is possible to effect the complete combustion of the carbon.
在通风良好的罩子里进行灼烧，但须防止其接触气流，并且在尽可能低的温度进行，以便使碳实现彻底燃烧。
The results show that in the high temperature zone of coal combustion and gasification elemental mercury is thermal stable form of Hg.
化学热力平衡分析结果表明，在煤燃烧和气化的最高温度区域里，单质汞是汞的主要形式；
By controlling combustion temperature or adding kaolin clay to make alkali metal salts into high melting substances, coking can be avoided in dense phase zone.
通过控制密相区燃烧温度或添加高岭土使之与碱金属钠盐形成高熔点物质，可避免密相区结焦。
Study shows that particle diameter, oxygen and temperature of combustion environment play an important role on burnout or time for burnout of coal.
研究表明，煤粉颗粒的尺寸大小、燃烧环境中的氧量及环境温度对煤粉的燃尽或燃尽时间有很大的影响。
In the drying system the combustion temperature of burner is the very important parameter, contrapose the burner, makes theoretically research of temperature controlling.
烘干系统中燃烧器的燃烧温度是至关重要的参数，本论文针对燃烧室温度控制作理论上的研究。
A new way to simulate combustion temperature and further for pollutants in direct-injection diesel engine is presented.
为计算直喷式柴油发动机缸内燃烧温度以及污染物成分提供新的计算方法。
Based on heat balance in dense phase zone, the relation of the circulation ratio. cycle ash temperature and combustion portion was calculated.
在密相区热平衡基础上。对循环倍率、循环灰温度与燃烧份额之间所关联的计算。
Internal combustion engines must maintain a stable operating temperature, not too hot and not too cold.
发动机必须保持一个恒定的工作温度，既不太热也不太冷。
Internal combustion engines must maintain a stable operating temperature, not too hot and not too cold.
发动机必须保持一个恒定的工作温度，既不太热也不太冷。
应用推荐