After cooler out at the exit of compressed air temperature should be saturated steam, and air temperature should be pressure of compressed air condensation point.
后冷却器出来的压缩空气在其出口温度下应该是水蒸气饱和的，且气流温度应该是压缩空气的压力凝露点。
As a result, higher mill entry temperatures, lower mill exit speeds at a given finishing temperature and thinner gauges in the austenite range could be realized.
结果，轧机的入口温度较高，实现了在给定的精轧出口温度较低，以及在奥氏体范围内更薄的压力表。
The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.
实际切圆直径是锅炉稳定安全运行的一个重要参数，炉膛出口残余旋转是造成烟温偏差的主要原因。
These methods have already been used for the gas temperature measurement at the exit of the high temperature rise combustor.
分析和比较了两种计算方法，这些方法已应用到燃烧室出口高温燃气温度测量中。
The FDV is controlled by a temperATure-sensing device locATed AT the exit of the heATing section of the system.
FDV受一个设置在设备加热段出口的温度传感器控制。
If gas composition flow rate and temperature at incinerator exit are given only, the capacity can be calculated approximately.
当仅知道焚化炉出口烟气各组分流量和温度时，能近似地计算出力。
Through crossed experiment, the effects of spinning speed, draw ratio, tow temperature at DF3 exit on strength and elongation of 1.
通过正交实验分析了纺速、拉伸倍率、DF3出口处丝束温度对1。
Because of this rapid attainment of equilibrium it is not practical to measure the temperature difference between gas and solid at the bed exit.
由于达到平衡很快，故测定床层出口处的气体和固体温度差是不实际的。
The results showed the influence on fiber strength and elongation at break was in draw ratio, spinning speed, DF3 exit temperature order.
对断裂伸长率的影响依次为拉伸倍率、纺速、DF3出口温度。
The results show that FTX polygon consumes less energy, the temperature of the polymer is lower at the exit of the extruder and its mixing ability is better than kneading block.
实验结果显示六棱柱元件能耗小、出料温度低、混合效果好，适用于玻璃纤维增强改性加工过程。
The waste heat loss is decided by the exit gas temperature and quantity, at fuel and air supply condition to keep stable, the exit gas quantity of the variety can be neglected.
而作为主要热损失的排烟热损失的大小直接决定锅炉效率的提高，排烟热损失的大小主要取决于排烟温度和排烟量，在燃料及送风条件保持稳定时，排烟量的变化可以忽略。
Results showed that the temperature, temperature gradient and thermal stress at the exit surfaces of the CWS ceramic nozzle were higher than that of other part of the nozzle.
结果表明：在陶瓷水煤浆喷嘴的出口端面存在较大的温度、 温度梯度和热应力。
Deviation of flue gas temperature at furnace exit may bring about harm to the safety and economic operation of the boiler.
锅炉炉膛出口烟温偏差给安全经济运行带来危害。
The results illustrate that primary air ratio has a major effect on pulverized coal ignition and minor effects on gas temperature, oxygen concentration and unburned carbon at furnace exit.
结果表明：一次风率对煤粉气流的着火影响较大，而对出口处烟气温度、氧量以及飞灰含碳量影响较小。
The calculated temperature, and flow fields as well as the composition of the raw gas at exit agree quite well with those observed in actual engineering cases.
得到了气化炉内的温度场、流场、浓度场以及出口粗煤气成分，其结果与工程实际相比非常接近；
The calculated temperature, and flow fields as well as the composition of the raw gas at exit agree quite well with those observed in actual engineering cases.
得到了气化炉内的温度场、流场、浓度场以及出口粗煤气成分，其结果与工程实际相比非常接近；
应用推荐