Open-loop unstable system with time delay is difficult to control using routine control methods.
开环不稳定时滞系统是工业现场中常见的一类被控过程,这类系统控制难度高,控制精度难以保证。
System instability may possibly occur if the control law designed in the case of no time delay is used for the control system with time delay.
若按无时滞时的控制设计对时滞系统进行控制,系统响应有可能出现发散。
The paper also refers several fuzzy PID intelligent composite control algorithms that are applicable to non-minimum phase system with time delay.
提出了几种适用于时滞及非最小相位系统的模糊pid智能复合控制算法。
According to the multivariable non-minimum phase system with time delay, the conditions of system decoupling and the points for attention are put forward.
对时滞及非最小相位的多变量系统,提出了系统解耦应满足的条件和需要注意的事项。
The dynamical behaviors of subsystem in coupling chemical reaction system with time delay as well as velocity perturbation were studied by numerical simulation.
在耦合自催化反应系统中,采用数值分析方法研究了考虑时滞效应和流速扰动时子系统的动力学行为。
Aiming to decrease overshoot, undershoot and settling time of non-minimum phase system with time delay, this paper proposes an intelligent IMC control system based on fuzzy inference.
为同时抑制时滞及非最小相位系统的超、负调和加快系统响应,本文提出一种基于模糊推理的智能内模控制系统。
The condition fits a general descriptor system, i. e., whether the descriptor system with time-delay is impulse-free or not, and it is less conservative than existing ones.
该条件适用于一般广义系统(无论系统中是否有脉冲行为),且具有较小的保守性。
A new multivariable predictive functional control algorithm is presented. The obtained MPFC algorithm can be applied to multivariable system with time-delay and disturbance.
提出了一种新的多变量系统预测函数控制算法,该方法可以适用于具有时滞和外部干扰的多变量系统。
So Neural Network has great significance to the control of a system with time-delay.
因此,神经网络对于时滞系统的控制具有重要的意义。
The nonlinear system with time-delay usually exists in the industry crystallizing process, so traditional control strategy can not meet the industry's requirement.
由于工业结晶过程存在非线性和滞后现象,因此采用常规的控制策略已经达不到工业生产的要求。
The nonlinear system with time-delay usually exists in the industry crystallizing process, so traditional control strategy can not meet the industry's requirement.
由于工业结晶过程存在非线性和滞后现象,因此采用常规的控制策略已经达不到工业生产的要求。
应用推荐