At last, in the section of software design, startup code programming, operating system choosing and transplanting, task design, drivers design and interrupt service routine design had been discussed.
最后，在软件设计部分探讨了启动代码编写、操作系统的选择和移植、任务规划和设计、驱动程序设计以及中断服务程序设计。
On software, we take full advantage of the low power modes of the MCU to finish the task in ISR (interrupt service routine), so, the power of system rest with the ISR executive time.
在软件设计上，充分利用所选单片机的低功耗模式，让检测任务在中断服务程序中完成，使系统的功耗主要取决于中断服务程序执行的时间。
NET system architecture, and describes the interrupt principle. In order to install the interrupt service routine, we present the way to modify the kernel and the OAL.
NET的系统结构，并详细阐述其中断原理，介绍如何修改内核和硬件抽象层安装中断服务例程。
After analysis the function of system software, main program, interrupt service program and subroutine were designed use modeling develop ways.
分析了系统软件的功能，采用模块化软件设计方法，设计了控制系统主程序、中断服务程序以及子程序。
The software consists of system initialization, display and interrupt service routines, which completes depth and velocity calculations, depth correction and alarm displays.
软件部分由系统初始化与显示程序和中断服务程序组成，主要完成深度、速度的计算、各种校正处理及显示各种报警等功能。
Which means a system must be tolerable of faults and can be maintained and upgraded without interrupt service. From the aspect of software, high availability revolves mainly around faults recovery.
这就要求系统能够容错，并能够在不中断服务的情况下维护与升级，从软件设计的角度来看，高可靠性以故障恢复为主要内容。
The system software includes the main program and interrupt service program.
系统软件主要由主程序和中断服务程序组成。
The design of digital control system includes DSP interrupt service routine and CPLD logic control.
数字控制系统软件设计，包括DSP中断服务子程序和CPLD逻辑控制。
Finally, this paper discussed the software system design based on above hardware platform, including the DSP initialization program, the interrupt request service and speech coding.
最后讨论了基于上述硬件系统的软件设计，主要分为三个部分：dsp的初始化程序、中断服务程序和语音编解码程序。
The software for control system was designed according to the timing requirement, the main program and the interrupt service program were highlighted.
根据热丝tig焊的时序要求，设计了控制系统的软件，重点介绍了主程序和中断服务程序。
The software for control system was designed according to the timing requirement, the main program and the interrupt service program were highlighted.
根据热丝tig焊的时序要求，设计了控制系统的软件，重点介绍了主程序和中断服务程序。
应用推荐