系统调试与测试。
Finally, the method of system debugging of hardware and software are analyzed.
最后给出了数字控制器硬件、软件调试方法。
Chapter 6 introduces communication between dual cores of DSP, and system debugging.
第6章概述DSP双核之间的通讯设计，和系统的联合调试。
Only programmers who do system debugging should be expected to deal directly with XML messages.
只能期望确实进行系统调试的程序员来直接处理XML消息。
Chapter six analyses the whole system debugging and test result so as to finish product at last.
第六章分析了整个系统调试和测试结果，完成最终的产品交验。
Manual pumps USES in under the system debugging and the special operating mode valve opens shuts.
手动泵用于系统调试和特殊工况下的阀门启闭。
The paper discussed the system scheme, principle, system debugging and error form the system design in detail.
本文从系统总体设计的角度，对整个系统的方案、原理、调试以及误差等方面进行了详细的论述。
This important for system and software and system debugging and underlies most system and software complexity measures.
这对于系统、软件、和系统调试非常重要，并且成为大多数系统和软件复杂性测量的基础。
Please coordinate with us if you meet the problem with the equipment maintenance, upgrades, system debugging, etc.
如果遇到设备维护、升级，系统调试等情况，请您配合我们的工作。
At last, this paper discusses some problems in course of system debugging and points out the next step of the work.
最后，分析了系统调试过程中存在的问题，明确了继续改进的思路和方向。
Hardware and software design for the CAN nodes and PC-CAN adapter and system debugging were finished in this project.
完成了CAN节点、PC - CAN适配卡的软、硬件设计和整个系统的调试工作。
Chapter 5 introduces the system debugging and maintenance, given the main electrical system schematic and wiring diagram.
第5章介绍系统调试与维护，给出了系统的主要电气原理图和接线图。
At last, some improvement is done aim at loading the driver stately which is the method of the embedded system debugging.
最后，针对驱动程序静态加载这种嵌入式系统调试的方法，进行了改进。
Finally, make the system debugging, the speed curve gained from experiment proves the feasibility of this control system.
最后，对所开发的系统进行了调试，通过实验得到的速度曲线波形证实了该控制器的可行性。
At last, the difficulties occurred in the system debugging and the simulation result of current testing channel are analysed.
文章最后对系统调试过程中出现的问题及电流检测通道的模拟检测结果进行了分析。
During the system debugging period, it's proved to be a fast swemar generator, which can implement very little frequency steps.
在系统联调期间，该模拟器可进行极小步进、快速扫频，取得了满意的多普勒模拟效果。
Combining with results of system debugging, some recommendations for further perfection of the said system have been put forward.
结合调试结果，对系统提出了完善化建议。
Then, the paper briefly describes the system debugging, including hardware debugging, software debugging, and gives the system debugging result.
然后，简要地叙述了系统的调试，包括硬件调试、软件调试，并给出了系统的调试结果。
Antenna system noise temperature and antenna efficiency are the most important items in the system debugging and checking before the VLBI observation.
在流动vlbi的观测试验中，天线系统噪声温度和天线效率是观测前系统调试和检测的两项重要内容。
The works are composed of system plan design, system hardware design, system software design, system debugging and analysis of real-time capability etc.
主要完成了系统方案设计、系统硬件设计、系统软件设计、系统调试、实时性分析等项工作。
An excellent encoding system of information is of great importance to the structure design, programming and system debugging and running of the database.
良好的信息编码系统对于数据库结构设计、程序设计和系统的调试、运行起着重要的作用。
This paper has finished the theoretical investigation and part experiment investigation of using image PWB inspection, and has carried out system debugging.
本文完成了印刷线路板图像检测的理论研究和部分实验工作，并且进行了系统的调试。
On the basics of them closed-loop temperature control was designed by us, and finally we are succeed in the combination of software and hardware system debugging.
本次设计在第一学期三个模块的基础上完成了温度闭环控制程序的软件部分，实现了软件硬件结合系统联调。
And the last part is about the hardware and software requirements of the wireless acceleration measurement system, and the method and result of the system debugging.
最后给出了无线加速度测量系统的硬件、软件和系统调试的方法和结果。
Conduct design reviews with the Factory Information system supplier (FIS) during the system development phase and assist the system debugging and on-site installation.
在系统的开发阶段，和工厂信息采集系统(FIS)的集成商进行设计评估。并协助系统的现场安装和调试。
Some problems about system debugging and application, including the high-speed transmission of multichannel infrared image, real-time display and processing, are solved.
该方法解决了系统调试和应用中多波段红外图像高速传输、实时显示与处理的问题。
In the end, the various parameters of the machine was set up, the lathe was checked and accepted after completing the mechanical parts and digital servo system debugging.
最后对机床的各参数进行了设定，在完成机械部分和数字伺服系统的调试后对该机床进行了验收。
The design of biochemical analyzer has been adopted online system debugging, it can run stably, and the result is correct, so the system design is reasonable and reliable.
本文设计的生化分析仪已经过系统的联机调试，运行稳定、结果正确，表明系统的设计是合理的、可靠的。
The design of biochemical analyzer has been adopted online system debugging, it can run stably, and the result is correct, so the system design is reasonable and reliable.
本文设计的生化分析仪已经过系统的联机调试，运行稳定、结果正确，表明系统的设计是合理的、可靠的。
应用推荐