Switching power supply or DC power to AC power through it will be a stable DC voltage source.
开关电源把直流电源或交流电源通过它可以获得一个稳定的直流电压源。
When switching a voltage source to multiple devices, it may become necessary to compensate for voltage drops due to switch resistance.
在将一个电压源切换至多个装置时，则可能必须补偿由于开关电阻引起的压降。
The duty ratios of switches in each switching cycle can be directly obtained by simple calculation using two phases source currents and dc bus capacitor voltage.
只需检测两相电源电流和直流侧电容电压，通过简单计算就可直接求出每个开关周期内各开关的占空比。
The hard switching approach (as shown in Fig. 26) doesn't consider the minimum drain-source voltage.
硬开关(图26所示)几乎不考虑漏源极电压的最小值。
General-purpose switches are usually sufficient for switching the voltage source unless high voltages (>100V) are involved, in which case, high voltage switch cards are necessary.
除了切换高压（>100V）时需要高压开关卡外，通用开关通常足以切换电压源。
The colour TV switching power constant voltage output related to the input voltage and the power source load.
彩色电视机开关电源的稳压输出与输入电压、电源负载有关。
Adding a resonance link to the traditional PWM inflexible switching circuit, a voltage-source inverter of high frequency and no switching less was formed.
具有共振直流环节的电压型逆变器是在传统的PWM硬件开关电路上加一个共振环节，构成高频、无开关损耗电压型逆变器。
For the use of off-line switching mode power supply IC, an internal power supply circuit combining with a high voltage startup current source is proposed.
结合高压启动恒流源设计了一种用于离线式开关电源的内部电源电路。
Therefore, this paper makes a comprehensive and systematic research of high voltage switching power supply based on Z-source inverter.
因此，本文对基于Z源逆变器的高压开关电源进行了全面系统研究。
In this control law multi-object function is created, which enables a voltage-source type inverter to produce a near standard sine wave with a minimum switching loss.
在这种新的逆变器开关控制策略中建立多目标优化函数，既使得电压型逆变电路输出电流波形总谐波畸变率尽量小，同时又能减小逆变过程的电力电子开关损耗。
In this control law multi-object function is created, which enables a voltage-source type inverter to produce a near standard sine wave with a minimum switching loss.
在这种新的逆变器开关控制策略中建立多目标优化函数，既使得电压型逆变电路输出电流波形总谐波畸变率尽量小，同时又能减小逆变过程的电力电子开关损耗。
应用推荐