Cached tables are distributed and synchronized to various hardware components so that processing can be distributed throughout the switch chassis.
缓存表分布在不同的硬件上，并些这些硬件之间同步。
The first switch in the chassis is normally located in the upper left of the blade chassis, just below the power plug.
机架中的第一个交换机通常放在刀片服务器机架的左上方，就在电源插头的下面。
If you are creating a redundant solution, it's important to split the primary and secondary switch between the upper half and lower half of the chassis.
如果要创建冗余的解决方案，就一定要把主交换机和辅交换机分别放在机架的上半部分和下半部分。
When creating network architecture for your blades, you must have one physical interface for each Cisco switch you want to use on the chassis.
在为刀片服务器创建网络体系结构时，对于机架上希望使用的每个Cisco交换机，必须有一个物理接口。
Ethernet interface ent0 on the blade maps to the first switch on the blade chassis; each consecutive Ethernet interface maps to the next available switch.
刀片服务器上的以太网接口ent0映射到刀片服务器机架上的第一个交换机；每个以太网接口依次映射到下一个可用的交换机。
Enter chassis chassis-mode TeraScale — Initializes the switch to tera-scale mode.
输入chassis chassis - modeTeraScale——把交换机初始化为tera - scale模式。
Enter chassis chassis-mode TeraScale — Initializes the switch to tera-scale mode.
输入chassis chassis - modeTeraScale——把交换机初始化为tera - scale模式。
应用推荐