This gets stuck on the cell's surface and then reacts with a stain that is added to the sample.
这种酶可以粘附到细胞的表面然后和一种添加的样本上的染色剂反应。
This photomicrograph was obtained by scanning a beam of electrons across the sample while a detector kept track of electrons bouncing off its surface, betraying the specimen's outer shape.
这幅显微照片是通过扫描穿过样品的电子束而获得的，同时检测器对从样品表面反弹的电子进行追踪，这些电子显示了标本的外形。
Atomic force microscopy generates very high-resolution images (about 5-nanometer resolution) by “feeling” the surface of a sample with a tiny probe tip.
原子力显微镜是运用一种微小的探针去“感受”样本表面，能得到高分辨率的影像（约5纳米的分辨率）。
And the surface beneath the sample molecule is usually metal, too, and its smooth, featureless mash of electron orbitals can camouflage the molecule lying on top of it.
在样品表面以下的分子通常也是金属的，并且它平滑的相似的电子轨道叠加能够伪装成它上面的分子。
Then they brought the sample back to room temperature and exposed it to an X-ray beam from the facility while using a CCD detector to record the X-rays reflected from the surface of the sample.
然后他们将样品重置于室温状态，并使其接受X射线照射，同时使用CCD检测器来记录从样品表面反射回的X射线。
The same forces that create surface tension in any sample of water are responsible for the maintenance of these unbroken columns of water.
在任何水样中造成表面张力的力支持着这些不断的水柱。
Another factor may be the mosquito’s search for an accessible vein near the skin surface, much like that of a nurse trying multiple sites to take a blood sample.
抑或是蚊子试图通过多点测试寻找一个接近皮肤的血管，正如护士采血样时多试几个地方一样。
This pushes molecules off the sample surface as gaseous ions, which can be detected and identified by the mass spectrometer.
这就使得分子以气化离子的形式离开样品表面，从而被质谱仪检测到并完成鉴定。
It is measured by placing two electrodes on the surface of the test sample, applying a potential difference between them, and measuring the resulting current.
其测量方法是将两个电极放在测试样品的表面，在电极之间施加一个电位差，并测量产生的电流。
Constructed of polystyrene with a smooth surface that provides accurate pour-outs with minimal sample loss and facilitates weighing of static-affected samples.
称量盘由表面光滑地聚苯乙烯材料制成。表面抗静电的特性最大程度地减少了样品的损失。
The sample is from the surface soil that scientists say covers a layer of ice.
科学家称上面覆盖一层冰的土壤样品是来自火星表层。
Philae will sample the surface, and also measure radio waves sent through the comet's bulk to probe its interior in the way that X-rays probe a human body.
菲莱会在表面提取样本，向彗星发射电波来探测它的内部就像X光探测人体一样。
Possibility to dope Y2O3 particle on the surface of superalloy sample and the relationship between homogeneity and irradiation parameters of laser have been investigated by means of laser irradiation.
本文通过激光辐照的方法，研究了在高温合金试样表面掺杂Y_2O_3质点的可能性、均匀程度与激光辐照参数的关系。
With a microscope, he observed the surface characteristics of the sample.
通过电子显微镜，他对样品的表征进行了观察。
An Electrostatic Force Microscope (EFM) for testing surface charge distribution of a sample is described.
描述了一种用于检测样品表面电荷分布的静电力显微镜(EFM)。
In photoelectric spectral analysis for a steel sample, the result depends on the condition of sample surface.
在对钢样进行光电光谱分析时，其表面情况对分析结果有直接影响。
Researchers initiated the study with the hypothesis that methods that sample the prosthesis surface should improve the diagnosis of prosthetic joint infection.
研究者假设从人工关节表面取样可能提高人工关节的诊断效率，研究以这样的假设开始。
With preheating temperature enhancing, the peak value also increase, but cooling velocity decreases, resulting from the decrease of heat conductivity of sample lower surface.
随着预热温度的提高，电阻峰值也相应增大，但是样品下表面的热导出率下降，冷却速度下降；
Hardness, tensile strength, breaking elongation ratio and aging property of samples were tested and surface of sample after aging was represented by SEM.
对试样进行了硬度、拉伸强度、断裂伸长率、热老化等性能试验；对老化后的试样表面进行了SEM表征。
The time to dielectric breakdown under magnetic field depended on the relative Angle between magnetic field and sample surface.
磁场环境下的绝缘破坏时间依赖于磁力线与试样表面的相对夹角。
Stereo light microscope which possesses relatively large depth of field, good performance in real-time and no breaking surface of sample, is used in stereo three-dimensional information measurement.
体视显微镜具有工作空间大、实时性高以及不损坏样品表面等优点，己用于微观对象三维立体信息的测量。
Sample A whose surface has layer structure via oxidize-deoxidize treatment and sample B which is decarbonization are put into resistance furnace for carbonization and quencher under hydrogen.
将其中试样A通过氧化-还原处理，表面具有层状结构，与另一脱碳试样B一起放入改造后的电阻炉内在通氢气的气氛中进行渗碳淬火。
The influence of sample surface status on analysis results was tested, and the absorbability and enhancement between elements were studied.
考察了试样表面质量对测量结果的影响，并对黄铜中元素间的吸收增强效应进行了研究。
This paper analyses that grinding of sample influence testing result of main element in copper alloy from three respect, emery cloth, grinding method, surface condition of sample.
本文从砂带，研磨方法，试样表面状况三个方面，分析了试样研磨对铜合金主要元素测试结果的影响。
The result show that tin is distributed on the surface of the sample made by reversing solidification, and the grain is fined, the hardness and resistivity are increased.
结果表明，在反向凝固中，锡可以分布于试样的表面，细化晶粒，提高试样的硬度，同时使电阻率升高。
The result show that tin is distributed on the surface of the sample made by reversing solidification, and the grain is fined, the hardness and resistivity are increased.
结果表明，在反向凝固中，锡可以分布于试样的表面，细化晶粒，提高试样的硬度，同时使电阻率升高。
应用推荐