This paper introduces the application of CANbus network in substation automation system SAS .
介绍了CAN总线在变电站自动化系统中的实际应用。
Not only will it be connected with substation and dispatching automation system but also can lay a foundation of distribution feeder automation system.
既能与目前广泛应用的变电站综合自动化、调度自动化系统相结合，又可为配电自动化打下基础。
Finally, the techno-economic criteria of design and operation of non-attended substation using integrated automation system are discussed.
最后，就采用综合自动化系统进行无人值班变电站设计和运行的一些技术经济判据进行了讨论。
The problem is discussed on connecting between management unit of DC control power system and field bus of the substation automation system.
对直流系统管理单元纳入变电所综合自动化系统现场总线进行了研究。
Communication network is the key section in substation automation system.
认为通信网络是变电所自动化系统的关键。
This thesis studies the technique problem of the synthesizing automation substation system towards layering distribute type.
本论文对分层分布式变电站综合自动化系统的技术问题进行了探讨。
In the substation automation system, the communication protocols adopted by protection relays are varied and the SCADA has to process many protocols simultaneously. The.
在综合自动化变电站中，继电保护设备采用的通信协议多种多样，监控系统必须同时处理多种协议。
At the end of this paper, it recounts the future development tendency of substation automation system and introduces some new technologies of hardware and software.
文章最后阐述了变电站自动化系统未来的发展趋势，并介绍了硬件和软件两方面的一些新技术。
In this paper, firstly, the substation general automation technology and the embedded system are summarized simply.
本论文首先对变电站综合自动化技术及嵌入式系统进行了简单概述。
As the improvement of the substation synthesizing automation, the requirement for communication system increases day by day.
随着变电站综合自动化水平的提高，对通讯系统的要求也日益提高。
Hence, it is necessary to popularize the use of microcomputers monitoring system in power plants and substations to enhance the level of automation of substation movement.
因此有必要在总降压变电站和各厂矿车间变电所推广设计采用微型机监控系统，以提高变电站运行的自动化水平。
Communication network is a key technique in substation automation system.
通信网络是变电站自动化系统的关键。
The outage of substation auxiliary power system has severe impact on the main transformer coolers, protection, communication and automation systems of substation.
变电站所用电系统全停故障将对变电所主变冷却器、保护、通讯、自动化等设备产生严重影响。
Circuit breaker tripping coil burning is a relatively frequent accident for the operation of substation comprehensive automation system.
断路器跳合闸线圈烧毁事故是变电站综合自动化系统在运行中较普遍的现象。
Finally, a substation automation system is designed, which is based on the MMS protocol.
最后，设计了一套基于MMS协议的变电站自动化系统方案。
The researching result is valuable for process bus communication design of the new substation automation system.
该研究结果对于新一代的变电站自动化系统过程总线通信设计具有参考意义。
The protection combines the functions of protection, control, measurement and remote communication together to act as an important part in automation system of substation.
装置集保护、控制、测量、遥信功能于一体，是变电站自动化系统的重要组成部分。
This method is based on expert system and its practice will enrich the high-level software used in integrated substation automation.
该智能控制方法建立在智能控制专家系统软件的基础上，它的开发研制丰富了变电站综合自动化的高层软件。
The unit style logic interlock device used in ultrahigh voltage substation automation system is introduced, which can easily implement the bay-level interlock.
介绍适用于超高压变电站自动化系统的单元化逻辑闭锁装置，该装置能方便、灵活地实现变电站间隔级闭锁。
A scheme for adding the function of multimedia information acquisition and transmission to the existing substation automation system by adopting the multimedia RTU is also proposed.
提出了采用多媒体rtu，以实现现有变电站自动化系统增加多媒体信息采集与传输功能。
Integrated automation system technology of transformer substation has been widely applied in operation of transformer substation of different voltage levels in our country.
变电站综合自动化系统技术已经广泛应用于我国各电压等级的变电站的运行中。
Substation automation control systems have become the development trend of power system control operations, the related substation automation control theory and practice are presented.
变电站自动化控制系统已经成为电力系统控制操作的发展趋势，本文就变电站自动化控制的相关理论和实践做了相关的阐述。
Non-electrical quantity detecting system is a new auto-control system that adapt automation of electric scheduling, self-service and integrating automatism in substation.
主变非电量测控系统是适应电力调度自动化、变电站实现无人值班化和综合自动化的一种新型自动测控系统。
This paper presents a substation automation system based on Fieldbus where PLC is used as the control unit.
本文提出了一个构建在现场总线网络之上，采用PLC作为控制单元的变电站自动化系统的实现方案。
Combined it with substation integrated automation system, the substation integrated automation simulation and training system has the wide applicative prospect in the power system of our country.
与变电站综合自动化系统共同组建的变电站综合自动化仿真培训系统，可在我国电力系统中推广应用。
Substation automation system USES memory database for real-time data access.
变电站自动化系统需要使用内存数据库对实时数据进行存取。
Based on this, by combining the operation sequence of control in substation automation, a security communication system of remote control for substation automation is designed.
在此基础上，针对变电站远程控制的安全需求，结合变电站自动化控制操作的动作序列，设计了变电站自动化远程控制的安全通信体系。
Research the application of 100m Ethernet in substation automation system, and provide a new network configuration of substation automation system base on 100m Ethernet.
研究快速以太网在变电站自动化系统中的应用，提出了基于100M以太网的变电站通信网的网络结构。
In this system the technology of automatic master station is used for the substation and on this basis a substation automation system is constructed.
该系统将自动化主站系统的技术引入变电站，构建了变电站自动化系统。
In this system the technology of automatic master station is used for the substation and on this basis a substation automation system is constructed.
该系统将自动化主站系统的技术引入变电站，构建了变电站自动化系统。
应用推荐