The control system model consists of control strategy, sensors and actuators sub models. The control strategy is a PID controller.
控制系统模型包括控制策略、传感器和执行器模型,本文选用的控制策略为PID调节器。
The hardware of the system comprises the five sub-systems, i. e. welding power source, arc length controller, welding wire feeder, welding head traveller and detector.
此系统的硬件主要包括五个子系统,即:焊接电源、弧长控制器、送丝机构、焊矩行走机构和检测机构;
Then the thesis states design decision on controller software system and the flow chart or the calculating description on sub-process of key module.
然后阐述了控制器软件系统设计方案,并给出关键模块子程序流程图或算法描述。
The paper used singular perturbation method to separate the Two-link Flexible Manipulator system into slow sub-system and fast sub-system and designed controller using Sliding Mode Co.
本文中采用奇异摄动方法将双连杆柔性机械臂系统分解为慢变和快变两个子系统,并对慢变子系统采用滑模控制方法设计了控制器。
This paper introduces a design of embedded temperature monitoring system which is based on CAN bus, the entire system composes by the embedded controller sub-master and the Master controller.
介绍了一种基于CAN总线的可扩展的嵌入式温度监测系统的设计方法,整个系统由嵌入式分控器和主控器两大部分组成。
Based on designing the observer, a switching strategy and sub-controller, which use the observer value, are designed to guarantee that the closed-loop system is exponentially asymptotically stable.
在所设计的观测器基础上,以系统状态的观测值为依据设计各子控制器和切换方案,使整个闭环系统是指数渐近稳定的。
This control system consisted of a host controller, multi master nodes , route nodes and sub nodes.
该控制系统由主控端、多个主控节点、各个终端子节点以及多个路由节点组成。
This paper mainly describes the composition of beam-steering system and the design of sub-array controller in beam-steering system.
本文主要论述了波控系统的设计及其中子阵波控模块的实现方法。
After analyzing the USB Device Controller function requirements, the thesis divides the system into several sub-modules by the way of TOP-DOWN.
在对usb设备控制器的功能进行详细的分析后,采用自顶向下的方法划分系统模块。
A cool fluid of a predetermined temperature is supplied to a three-way valve (20) of a sub unit (2) from a cooling side tank (43) of a main unit (1) of a controller, through a supply pipe (14).
来自恒温维持装置的主单元(1)的冷却侧水箱(43)的被调整到预定的温度的低温循环液通过供给配管(14)被供给给辅助单元(2)的三通阀(20)。
A cool fluid of a predetermined temperature is supplied to a three-way valve (20) of a sub unit (2) from a cooling side tank (43) of a main unit (1) of a controller, through a supply pipe (14).
来自恒温维持装置的主单元(1)的冷却侧水箱(43)的被调整到预定的温度的低温循环液通过供给配管(14)被供给给辅助单元(2)的三通阀(20)。
应用推荐