• Viscous sub-cycle time step and Lagrangian sub-cycle time step are adopted to accelerate convergence.

    采用粘性子循环时步、拉格朗日子循环时步加速收敛;

    youdao

  • Centralization, Sub urbanization, Counter urbanization and Re urbanization are the main phases in the life cycle of metropolis.

    向心城市化、城郊化、逆城市化和再城市化四个连续的变质阶段构成大都市的生命周期。

    youdao

  • Based on stepwise optimization strategy, this method separates the multicycle optimization problem into two sub problems: simplified multicycle optimization and single cycle optimization.

    利用分步决策的优化策略,多循环优化可以分解为一个两步优化问题。

    youdao

  • A math model of the sub structure level is built to calculate the work cycle.

    为设计计算工作循环,建立了该模型结构子层的数学模型。

    youdao

  • To determine the new gain, polarity peak ending and starting time, cycle (run) length, etc., you will need to enter the sub diagnostic menu called trending.

    确定一个新的增益,极性峰的结束和开始时间,周期运行时间长度,等等,你将需要进入辅助诊断菜单检查趋势。

    youdao

  • In the design of current-mode PWM DC-DC converters, the slope compensation method widely used to prevent sub-harmonic oscillation can significantly weaken the load capacity under a high duty cycle.

    电流模pwm集成dc - DC变换器设计中,为了防止亚谐波振荡而普遍采用的斜坡补偿,会在占空比较大时严重影响芯片的带载能力。

    youdao

  • This dissertation is one of the sub-problems of "Computer Dynamic Test and Calculation of Welding Heat-cycle", which is a project on natural science fund.

    本文是自然科学基金项目“焊接热循环的计算机动态测试与计算”的一个子课题。

    youdao

  • Results: (1) Sub-confluent cells having starved in DMEM containing 0.4% FBS for 48h, 88.5% of the cells were at G0/G1 phase of the cell cycle.

    研究结果表明:(1)培养至次融汇状态的乳鼠心脏成纤维细胞经低血清(0.4%FBS)饥饿培养48小时,G0/G1期细胞占88.5%;

    youdao

  • These stages are called "sub-circadian rhythm cycle."

    这些阶段被称为“次昼夜的节拍周期。

    youdao

  • And then, we mainly discuss the peak current controlling mode and the sub-harmonic oscillation when the duty cycle exceeds 50%.

    同时,着重分析了峰值电流控制模式下,由于电流扰动和占空比扰动导致系统在占空比大于50%情况下而出现次谐波振荡原因。

    youdao

  • And then, we mainly discuss the peak current controlling mode and the sub-harmonic oscillation when the duty cycle exceeds 50%.

    同时,着重分析了峰值电流控制模式下,由于电流扰动和占空比扰动导致系统在占空比大于50%情况下而出现次谐波振荡原因。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定