The fractures are always controlled by the tectonic stress distribution; therefore, to study the paleo-stress field is a useful method to predict the fractures.
由于构造裂缝主要受控于构造应力场，从构造应力场分析入手预测构造裂缝发育规律是十分有效的手段。
AIM: to investigate the effects of torque force load on the stress distribution in implant bone interface, so as to help the clinical selection of implant location.
目的：研究扭转力载荷对支抗种植体骨界面应力分布的影响，以指导临床正确选择支抗种植体的植入部位。
Aiming at reasonable stress distribution of tower and girder, reasonable alignment of bridge, FEM computation and optimization analysis are combined to determine the reasonable cable tension.
以塔和梁的应力分布合理及梁的线形为目标，采用有限元计算与优化分析相结合的方法来确定斜拉桥的合理成桥索力。
And the stress distribution can also be improved.
同时节点的应力分布也得到改善。
The results were shown by histogram and stress distribution chart .
结果以统计直方图，应力分布图等表示。
High residual stress distribution zone lies in the center of work piece.
平板工件中心存在较大的残余应力分布区。
Objective: To realize normal stress distribution of lumbar vertebral body.
目的：了解正常人腰椎椎体的应力分布特点。
It is very important to know the stress distribution of anchorage zones under cable forces.
掌握锚固区域在斜拉索作用下的应力大小及分布是十分重要的。
The magnitude and direction of force could not change the trend of the stress distribution.
牵引力的大小、方向基本不改变应力的分布趋势。
The stress distribution of cable-pylon anchorage zones under U-prestressing tendon is analyzed.
分析了U形钢束作用下索塔锚固区应力大小及分布情况。
Meanwhile, the fillet geometry has played an important role on this thermal stress distribution.
同时，钎缝圆角几何形状对这一热应力分布有重要影响。
Objective:To observe the stress distribution of the FPD, which used the loosen teeth as abutments.
前言： 目的：观察松动牙作基牙时，固定桥支持组织的应力分布。
The thermal stress distribution of SCSP in packaging process was studied by finite element method.
利用有限元法研究了堆叠芯片封装(SCSP)器件在封装工艺过程中的热应力分布。
Objective: To study the traits of intra-stress distribution of lumbar during rotatory manipulation.
目的：研究坐位旋转手法时对腰椎内在应力分布的特点。
Objective: To evaluate the effect of the stress distribution of dentine under post crown prosthesis.
目的：分析桩冠修复后对根管壁牙本质应力分布的影响。
Shear theory was used to analyze stress distribution on double cutting of brown rice and cooked rice.
应用剪切理论分析了稻米及米饭的双面剪切的应力分布。
The stiffness and stress distribution of the micro-feeding system are obtained through static analysis.
通过静力分析得到了微进给刀具系统在静力作用下的变形和应力分布。
The stress distribution rule of surrounding rock is obtained and surrounding rock stability is analyzed.
据此，得出围岩的应力分布规律，进行围岩稳定性分析。
The non-linear finite element method was used in this paper to analyze the stress distribution in the area.
本文采用非线性有限元方法，对极限工况下该区域的应力状态作了分析计算。
Objective To study stress distribution in jawbone tissues around dental implant under displacement constraints.
目的研究指定位移约束对颌骨的应力分布影响。
According to the regulation of axial stress distribution, a way to design the rational end construction is given.
根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。
This paper calculates the stress distribution of prestressed rock anchor by the non-linear finite element method.
本文采用非线性有限元法计算了胶结式预应力岩锚胶结体和基岩的应力及其分布。
Manufacture method of anchor bolt plate is introduced and stress distribution in laboratory is analyzed in this paper.
介绍了锚杆测力托盘的制作方法，在实验室对锚杆托盘的应力分布进行了分析。
The effect of the recessing on the strength and stress distribution of adhesively bonded single-lap joints is discussed.
研究单搭接接头胶缝中预留间隙对接头拉剪强度和应力分布的影响。
The shape design of attachment post is crucial factors influencing post retention and stress distribution to the dentin.
附着体桩柱形态的设计不仅影响到桩柱固位，而且影响牙本质应力分布。
This method differs greatly from the present general calculation method in the stress distribution of controlled section.
此法与一般的计算方法相比在控制截面的应力分布方面有大的差别。
Through a large amount of calculation, the stress distribution Pattern of beam axle is obtained for some main load cases.
通过大量计算，对应于几种主要的载荷工况，得到了车桥横梁的应力分布规律。
The width and depth of laser transformation hardening zone and residual stress distribution were measured experimentally.
实测了激光相变硬化区的宽度和深度及残余应力分布。
The sectional temperature and stress distribution of optical films under high power pulse laser irradiation are calculated.
计算了薄膜在高功率脉冲激光作用下截面温度场和应力分布场。
The sectional temperature and stress distribution of optical films under high power pulse laser irradiation are calculated.
计算了薄膜在高功率脉冲激光作用下截面温度场和应力分布场。
应用推荐