Stress boundary condition in the nonlocal linear elasticity theories is an unsolved problem.
应力边界条件的提法是线性非局部弹性理论尚未解决的一个理论问题。
Stress boundary condition in the nonlocal linear elasticity theories is an unsolved problem. In this paper, this problem is studied.
应力边界条件的提法是线性非局部弹性理论尚未解决的一个理论问题。
The unknown bottom, stress boundary condition can be determined by the iterative formulae given herein. The approach is verified through model experimental data.
未知的筒底应力边界条件，通过迭代法确定，建立了无底筒仓内填抖压力的一种计算方法，并与模型试验结果进行了比较。
A new stress element near a hole which satisfies both the stress boundary conditions at the hole and at the surface of the laminate and stress continuity condition at the interface is developed.
构造了一个满足孔边应力边界条件、层间应力连续条件以及层合板表面应力边界条件的孔边应力单元。
The simulation of geometric boundary condition and the division of computation mesh also affect the computation result of the slab stress to some extent.
对几何边界条件的处理、单元网格的划分也会对面板的计算应力产生一定的影响。
Second-order cumulative waves have been fully determined by applying the boundary condition of second-order stress.
根据二阶应力边界条件，确定出了固体板内的二阶积累波。
The proposed finite difference boundary condition expands the scope of application of FDTD to scattering problems of objects with a finite acoustic impedance but without tangential stress.
导出了水中透声目标表面边界条件的时域有限差分(FDTD)表达形式，将FDTD在水声学中的应用范围扩大到无切应力的有限声阻抗目标的散射问题。
A function of distance between initial stress strain point and point at state boundary surface is adopted to simulate stress strain behaviour of soil in condition of small strain.
采用从初始应力点到状态边界面的距离为参数的系数来修正硬化准则以模拟土体小应变条件下的应力应变特征。
Through indoor simulated test, the influence of boundary condition, size effect, radius ratio, stress state and relative density on cone resistance be determined.
通过分析影响室内模拟试验的影响因素，得到室内试验修正系数与侧向边界条件、半径比、初始应力状态以及相对密度的关系曲线。
The result indicates that the seepage field, slope angel, and the boundary condition is influence the stress field. And several conclusions are gained from this analysis.
分析结果反映渗流场、坡角、边界条件均对围岩应力场产生影响，并从中得到一些相关结论。
Abstract A finite element model for thefront door system is build, boundary condition is performed to simulate thereal situation, time history of stress is obtained through calculating byABAQUS.
摘要以某型轿车车门为例，建立了前侧门系统的有限元模型，施加了边界条件以模拟实际工况，并采用 ABAQUS求解器计算获得了应力时间历程。
By integrating the dynamic equilibrium equation of porous media and using the boundary condition, total stress and fluid pressure are determined in turn.
对整体平衡方程关于空间坐标积分，根据边界条件可确定总应力，并进而求得孔隙压力。
Separation of variables is employed to solve the differential equation under the boundary condition of two ends of the girder being simply supported, and the solution of stress is…
在两端简支的边界条件下采用分离变量法求解偏微分方程，得到用级数表示的应力解，然后根据剪力滞系数的定义即可得到组合箱梁翼板的剪力滞系数。
The effects of finite length and finite width on the stress intensity factor are achieved by using the fundamental solution and the boundary condition.
利用基本解和边界条件可以计算板长和板宽对应力强度因子的影响。
The cylindrical shell with various boundary condition are considered. The formulae of collapse load, stress field and velocity field and the judgement equations for long or short shells are given.
分析了在各种边界条件下的圆柱壳，给出了极限载荷、应力场和速度场的全部公式以及长壳和短壳的判断公式。
The stress intensity factor of crack can be calculated from the stress concentration factor of corresponding notch when the boundary condition and other geometric conditions are in the same.
在边界条件和其他几何条件相同时，可以通过切口的应力集中系 数求得相应裂纹问题的应力强度因子。
The NNE fault system is mainly controlled by tension-torsional stress, and the NNE-NE fault system by these factors: boundary condition, sedimentary facies zone and regional tensional stress.
NNE向断裂系统主要受张扭应力作用控制；而nne - NE向断裂系统主要受边界条件、沉积相带、区域张应力的控制。
The NNE fault system is mainly controlled by tension-torsional stress, and the NNE-NE fault system by these factors: boundary condition, sedimentary facies zone and regional tensional stress.
NNE向断裂系统主要受张扭应力作用控制；而nne - NE向断裂系统主要受边界条件、沉积相带、区域张应力的控制。
应用推荐