Rapid wet strength test method of fruit cultivation bag paper can be applied for production and quality control.
采用生产快速检测方法检测育果袋纸的湿强度，可以满足生产及产品质量控制要求。
Static trials represent an experimental test method of defected mode and static strength of a plane construction.
静力测试提供了一种检测飞机机体结构破坏模式以及静强度的试验方法。
Moreover, the test data were statistical treated with the method recommended by IIW and compared with fatigue strength of structural steel with identical joint type.
用国际焊接学会推荐的方法进行统计处理，并和相同接头形式结构钢的疲劳强度进行了比较。
The steady state strength concepts, the consolidated-undrained triaxial shear test method and the test results are introduced.
介绍了稳态强度理论的基本概念、稳态强度的固结不排水剪切试验方法及试验结果；
The method of dynamical measurement which was applied to analysis of pile driving is extended to test and measurement on the stiffness and strength of vertical joints between diaphragm walls.
将用于桩基检测的动测法，推广应用于地下连续墙纵向接缝刚性和强度的测试。
Standard Test Method for dielectric breakdown voltage and dielectric strength of D149 ASTM solid electrical insulating materials at industrial power frequencies.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
This paper introduces the test results and calculative method by using the composite foundation of sand-stone pile and concrete pile with low strength.
本文通过试验与工程实践，介绍采用碎（砂）石桩及低强度混凝土桩组合构成复合地基的试验成果、计算方法及应用检测成果。
Test study is the most important research method of ultimate strength of tubular joints.
试验研究是研究钢管节点承载力性能的最重要的方法。
The paper describes the measurement method for model surface temperature and model surface illumination strength in wind tunnel optical pressure measurement test by the virtual instruments.
本文介绍了在风洞光学测压试验中应用虚拟仪器技术对模型表面温度和模型表面光照强度的测量方法。
Diametral point load test is a very promising, simple and accurate method for obtaining compressive and tensile strength data of rock core.
用岩芯进行径向点荷试验，是简单而较精确地获得岩石抗拉、抗压强度的极有前途的方法。
Method Mud invasion process is simulated with conventional three axis rock strength test device under same downhole pressure and temperature.
方法采用常规三轴岩石强度试验装置，进行井下温度压力条件下的泥浆侵入过程模拟试验。
The influence factors and strength variation of the deep mixing pile are analyzed, and the application of reflected wave method in the deep mixing pile test is investigated.
对深层搅拌桩强度变化及影响因素进行了分析，并就反射波法在深层搅拌桩检测中的适用性进行探讨。
This paper introduces a kind of new method of cool rolling, shock and rolling, for making rounds of high strength bolts. Its working principle and test results are described.
介绍了一种用于高强度螺栓圆角冷滚压的新方法——冲击滚压，简述了它的工作原理及试验结果分析。
The cube cleavage test is an indirect method to determine the tensile strength of concrete.
立方体劈裂试验是测定砼抗拉强度的间接方法。
The disadvantage of API filtration test to evaluate mud cake quality is analyzed. A method, taking mud cake strength, permeability and thickness as main evaluation factors is introduced.
分析了API滤失试验的缺点和确定泥饼质量的关键因素，介绍了用泥饼强度、泥饼渗透率和泥饼厚度评价泥饼质量的试验方法。
Through using the method of maximum strength capacity threshold, this paper made test and study on strength endurance of 10 male and female elite speed skaters in short distance in China.
运用“最大力量能力阈”的测试方法，对国内10名男子和10名女子优秀短距离速滑运动员的力量耐力进行测试与研究。
The contrast method of simulated accelerated test and sample test has been used to investigate contacting surface strength of gears and both similarities and differences have been found between them.
用模拟快速试验与实际试件试验的对比方法，对齿面接触强度进行了研究，表明两者之间有异同之处。
A kind of method to evaluate and test the tension-compression fatigue strength of gray cast iron was introduced in this paper.
介绍了一种评价与测试灰铸铁铸件的拉压疲劳极限的方法。
The method of toughness test such as Direct Crack Measurement and Indentation Strength by Bending etc. Are also introduced.
介绍了直接压痕法、弯曲压痕强度法等几种韧性测试方法。
Delay: damage test method suitable for high strength steel hydrogen brittleness test, is a sensitive and reliable test method.
延迟破坏试验﹕此法适合于超高强度钢的氢脆试验﹐是一种灵敏而可靠的试验方法。
From increasing the strength and density of concrete to start, the test and research were carried out for the sample of cement mortar by using PIC method in this paper.
从提高混凝土强度和密实性出发，采用“PIC”法对水泥砂浆试块进行试验和研究。
Through test and analysis of working stress on balance beam and lengthwise beam of dozer frame, a strength design method and the basis for compiling load spectrum are given in the paper.
通过对推土机平衡梁和车架纵梁的工作应力测定与分析，掌握了推土机的强度设计方法，为编制载荷谱打下基础。
Model test has been one prevalent method to study the ultimate strength of hold sections.
模型试验是研究船体结构极限强度的重要方法之一。
The concept and application of "SHANSEP" were proposed as a new laboratory test method which can minimize the sampling disturbance and more correctly estimate the undrained shear strength of clay.
减少土样扰动，准确评估粘土不排水抗剪强度的“SHANSEP”室内试验方法及应用。
In order to study the interfacial bond strength better, this paper developed a new method and test device of the interface.
为更好地评价界面粘结强度，论文开发了界面的成型方法与测试装置。
The influence of cement soundness on concrete strength and the method of simple test for soundness of cement in concrete have been discussed.
讨论了水泥安定性对混凝土强度的影响以及混凝土中水泥安定性的简易检验。
A new method was given to test the cohesion strength of weak interface of DISC by tensile tests and shearing tests.
提出了一种利用拉伸法和剪切法测定内生复合板钢板弱界面拉伸强度及剪切强度的测试方法。
This method is used to test concrete strength of building structure, so the question of building in-site strength curve is resolved effectively.
将文中方法运用于回弹法检测混凝土强度中，有效解决了现场测强曲线建立问题。
The calibration principle and method of the near region field strength meter are described, especially its auto calibration and test system and the study of software.
介绍了近区场强仪的核准原理和方法，着重介绍了近区场强议的自动校准测试系统和软件的研究。
The calibration principle and method of the near region field strength meter are described, especially its auto calibration and test system and the study of software.
介绍了近区场强仪的核准原理和方法，着重介绍了近区场强议的自动校准测试系统和软件的研究。
应用推荐