• Through heat treatment, material hardness and strength increase, but impact toughness decreases.

    热处理后,材料的硬度和强度均有提高,但冲击韧度下降。

    youdao

  • The main reason for strength increase of V microalloyed steel is ultra-fine microstructure in TSCR process.

    组织超细化是导致薄板坯连铸连轧流程V微合金钢强度提高的主要原因。

    youdao

  • Pipe strength increase is an important guarantee for assuring the safety of buildings and structures along pipeline.

    提高管道自身强度是对管道周围建构筑物安全的重要保证。

    youdao

  • To split tensile strength and flexural strength, with the increase of air content, strength increase firstly and then decrease.

    对于劈裂抗拉强度和抗折强度而言,随着含气量的增加,强度先增加后减小。

    youdao

  • PEI 5% in the content, the composite material has better mechanical properties, bending strength increase by 28.0%, impact strength 26.1%.

    在PEI含量5%左右时,复合材料的综合力学性能较佳,弯曲强度提高了28.0%,冲击强度提高了26.1%。

    youdao

  • This paper briefly introduces the calculating method for controlling strength increase of concrete in winter construction with critical maturation degree.

    本文简要介绍了用临界成熟度控制冬季施工混凝土强度增长的估算方法。

    youdao

  • The contact angles decrease, the roll angles increase, the antifouling performance gets small and the adhesion strength increase with the increment of space of the microstructure.

    随着微结构间距的增大,接触角减小,滚动角增大,抗附着性能降低,附着强度增大。

    youdao

  • The results show that tensile strength and yield strength increase generally, while total elongation and product of strength and ductility decrease with the increase of strain rate.

    结果表明,随应变率的增加,抗拉强度与屈服强度总体呈上升趋势,而断裂伸长率及强塑积单调下降。

    youdao

  • The results show that the porosity and water absorption decrease and the bulk density and bending strength increase, along with the sintering temperature raising and the time prolonging.

    结果表明:随着烧结温度的升高和保温时间的延长,气孔率和吸水率减小,体积密度和弯曲强度升高;晶粒长大填充气孔,使多孔材料孔隙率下降而强度增加。

    youdao

  • The results show that the porosity and water absorption decrease and the bulk density and bending strength increase, along with the sintering temperature raising and the time prolonging.

    结果表明:随着烧结温度的升高和保温时间的延长,气孔率和吸水率减小,体积密度和弯曲强度升高;晶粒长大填充气孔,使多孔材料孔隙率下降而强度增加。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定