Hardware consists of microcomputer, stepping motor control card, stepping motor driver and stepping motor and so on.
硬件由微机、步进电机控制卡、步进电机驱动器和步进电机等器件组成。
The article exploits a special NC system based on DOS, choosing PCL-839 3-axis stepping motor control card, and analyzes the expansibility of the card.
文章采用PCL-839三轴步进电机控制卡开发了一套基于DOS的专用数控系统,并对该控制卡功能的扩展进行了分析。
One kind of stepping motor control card based on ISA bus of PC which achieved multi-spindle linkage control is introduced, its principle and design of hardware construction and software are discussed.
介绍了一种基于PC机的IS A总线步进电机控制卡,实现多轴联动控制,讨论了其工作原理和硬件结构设计、软件设计。
One kind of stepping motor control card based on ISA bus of PC which achieved multi-spindle linkage control is introduced, its principle and design of hardware construction and software are discussed.
介绍了一种基于PC机的IS A总线步进电机控制卡,实现多轴联动控制,讨论了其工作原理和硬件结构设计、软件设计。
应用推荐