Based on ternary model method, the mathematical model of strip steel annealing process in vertical furnace is built.
以三元模型法为基础,建立了带钢在立式炉内退火全过程的数学模型;
To introduce the configuration, control method and software of the automatic control system for stainless steel annealing and pickling line.
介绍不锈钢退火酸洗处理线自动控制系统的组成,控制思想和软件。
The stainless steel annealing and pickling process can product large quantity of waste mixed acid(HF/HNO3) that must be treated through acid purification system.
不锈钢生产退火酸洗过程会产生大量废混酸(HF/HNO3),通过酸净化系统对废酸进行处理。
The procedures of heat treatment of steel include hardening tempering annealing and case hardening.
钢的热处理工序包括硬化、回火、退火和表面硬化。
There are three main operations in the heat treatment of steel: hardening, tempering and annealing.
钢的热处理操作主要有三种,即:淬火,回火和退火。
There are three main operations in the heat treatment of steel: hardening tempering and annealing.
钢的热处理操作主要有三种,即:淬火、回火和退火。
The process of annealing consists of heating the steel to an elevated temperature for a definite period of time and, usually, cooling it slowly.
退火工艺的组成为把钢加热到一定温度并保持一段时间,通常再缓慢冷却。
The application of quartz ceramics roll in silicon steel continuous annealing furnace was introduced.
本文介绍了石英陶瓷辊在硅钢连续退火炉中的应用情况。
The effects of baking temperature, baking time and prestrain on the bake hardenability and dent resistance of isotropic sheet steel and BH sheet steel produced by batch annealing were studied.
研究了烘烤温度、烘烤时间和预拉伸应变量对罩式炉退火工艺生产的各向同性钢的烘烤硬化性的影响,并与力学性能相当的冷轧烘烤硬化钢进行了对比。
This paper presents some results of heat treatment experiments of A508-3 steel at different quenching, tempering and annealing conditions.
本文介绍国产A508-3钢在不同的淬火、回火和退火条件下的热处理实验的某些结果。
When the annealing temperature has been reached, the steel should be held there until it is uniform throughout.
达到退火温度后,钢应当保持在此温度等到全部均匀受热。
The test results show that the surface of H13 steel can obtain the optimum performance at temperature of complete annealing, quenching and tempering.
试验结果表明H13钢在最佳完全退火温度、淬火温度、回火温度下可得到最优综合性能。
The results show that the hardness of H13 steel after annealing depends on size, relative amount and type of carbide.
明确了H13钢退火后硬度的高低与碳化物粒子的大小、相对量及碳化物的类型的依赖关系。
The influences of cooling rate after the forge on the heating temperature and time of apheroidized annealing of steel T10 was studied.
研究了锻造后的冷却速度对T10钢等用球化退火加热温度和保温时间的影响。
Analysis on the microstructure shows that precipitation of compound containing titanium was found in the steel, and its amount increases with the elevation of annealing temperature.
显微组织分析表明,含钛钢中生成了钛化物相,并且随着退火温度的提高,钛化物析出量增多。
Toughness of powder forging steel can be increased efficiently by diffusion annealing in longer time.
长时间扩散退火可有效地提高粉末锻造钢的韧性。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
介绍了无涂层电工钢冲片叠片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hydrogen furnace was introduced.
介绍了无涂层电工钢冲片迭片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
Maintenance methods: replace the precision of the clutch wheel and the small steel wheel or wear the gear after annealing treatment, repair the wear gear and then annealing the gear quenching.
维修方法:更换精准表离合轮和小钢轮或者把磨损齿轮经过退火处理,修复磨损齿轮再把退火的齿轮进行淬火处理。
The secondary recrystallization and its temperature range of grain oriented silicon steel have been studied by the method of interrupting secondary recrystallization annealing.
采用"中断法"研究了取向硅钢二次再结晶过程中的异常长大行为,确定了二次再结晶发生的温度范围。
Maintenance methods: replace the rolex clutch wheel and small steel wheel or the wear gear after annealing treatment, repair the wear gear quenching of gears to the annealing treatment again.
维修方法:更换表离合轮和小钢轮或者把磨损齿轮经过退火处理,修复磨损齿轮再把退火的齿轮进行淬火处理。
To meet uninterruptedly increasing in the demand for the cold rolled steel sheets and to meet the technological demand of continuous annealing, the production of ultra-low carbon steel is increasing.
为了满足市场对冷轧薄板钢需求量的不断增加和连续退火工艺要求,超低碳钢生产也在不断增加。
In addition, both hydrogen permeation time and trapping coefficient of hydrogen increase but the hydrogen diffusivity decreases in the steel with the elevation of annealing temperature.
此外,随着退火温度的提高,氢渗透时间和氢陷阱系数也增大,而氢的扩散系数则降低。
This paper introduces three methods of rapid softening and annealing for high speed steel. There are many advancetages of energy-saving, short cycle and low cost.
本文介绍了高速钢快速软化退火的三种方法。这些方法具有节能、高效、周期短、成本低等特点。
Some observations of voids formation were carried out by using low carbon steel with three kinds of heat-treatment, namely, normalizing, annealing and spheroidizing.
对三种不同热处理(正火、退火、球化)的低碳钢中微空洞的形成进行了一些观测。
The microstructure morphology of spheroidal graphite cast steel after as-casting, annealing, normalizing, forging was investigated emphatically in this paper.
重点分析了球墨铸钢铸态、退火、正火、锻造后的组织特征。
Oxidation factors in annealing of seamless steel tube are analyzed, combining with production practice, some methods have been put forward to decrease oxidation of seamless steel tube.
分析了无缝钢管退火中的氧化因素,结合生产实际,提出了减少无缝钢管氧化的措施。
Ultrasonic testing shows on flake defects in theheavy forgings of ESR steel without any diffusion annealing.
未经扩氢退火的电渣钢大锻件经超声波检验,未发现白点缺陷。
The ingot annealing technology in some alloying steel plant have been investigated.
调查分析了一些特殊钢厂的钢锭退火工艺规范。
The ingot annealing technology in some alloying steel plant have been investigated.
调查分析了一些特殊钢厂的钢锭退火工艺规范。
应用推荐