The finished rotor and stator unit is then assembled into a central motor housing unit. The motor assembly is then subjected to a High-Potential (Hi-Pot) Test.
转子和定子成品然后装配进中央电机壳装置内。随后电机总成需经过高电压测试。
The cause of vibration on the turbogenerator stator end winding is analyzed, and the meaning of natural frequency test and vibration measurement is discussed.
本文分析了引起汽轮发电机定子绕组端部振动的原因，以及固有频率试验和振动测量的意义。
The structural features of a new type of circulating-pump motor with shielded stator and its test as well as its comparison with wet-winding motor are described in this paper.
介绍了新型屏蔽式定子结构的炉水泵电机的结构特点、应用及试验，并与湿定子结构炉水泵的应用进行了对比。
The stator winding of power frequency withstand voltage test.
定子绕组做工频耐压测试。
The direct-current leakage test is implemented by using the microampere shielded in low-voltage, and the leakage current increasing of generator stator winding abnormally is detected.
采用低压屏蔽法对发电机定子绕组进行直流泄漏试验，发现泄漏电流异常增大。
According to the results of noise test, the effect of stator curve to automobile power steering pump noise were analyzed.
根据噪声测试结果，分析定子曲线对转向泵噪声影响。
With the rotor driven by the test device, eddy currents are induced in the rotor opposing an equal electro-magnetic force generated in the restrained stator.
随着转子被测试系统驱动，在定子的限制下，转子中会产生相反于电磁场方向的涡流。
A new plugging test method for water cooled stator coil was described in this paper.
介绍了一种新的检查水冷定子线圈堵塞的方法。
The test results show that the ground fault at any point of the stator of a large unit-type generator-transformer system can be successfully protected.
试验结果表明：大型发电机一变压器组的定子的任何一点上发生接地故障时都能成功地获得保护。
The standard is applicable to stator coil and winding insulation alternative and direct current voltage withstanding test for AC generator, synchronous phase modifier and AC motor.
本标准适用于交流发电机、同步调相机和交流电动机定子线圈及绕组绝缘交、直流耐电压试验。
In this paper, the test for vibration mode of stator core of an electric - al motor are studied using the transfer function mode techniques.
本文用传递函数的模态分析法研究了电机定子铁芯的振动模态，介绍了试验原理、装置及测试结果。
The purpose of stator iron test is to assess the assembly quality of a new iron from it's actual loss.
铁损试验的目的是检验新装铁心的绝缘情况和实际损耗，判断铁心的安装质量。
The purpose of stator iron test is to assess the assembly quality of a new iron from it's actual loss.
铁损试验的目的是检验新装铁心的绝缘情况和实际损耗，判断铁心的安装质量。
应用推荐