The practical comparison shows that this method can reduce cost of static load experiment.
同时通过实例对比说明，这种方法对于静载荷试验具有一定的经济效益。
Bridge static load experiment is main method to identify the safety of bridge board and beam.
桥梁静栽试验是鉴定板(梁)能否安全使用的主要方法。
Static load experiment is the most basic and reliable method for ensure single pile bearing force.
静载荷试验是确定单桩承载力方法中最基本、最可靠的方法。
On the base of static load experiment and the finite element method, three major contents have been made.
简要介绍了城市轻轨钢轨道梁在工厂内进行静荷载试验的方法和步骤，同类工程具有借鉴意义。
Through static load experiment on Prestressed Inclined Plate bridge, combined with theory analysis, evaluating bearing capability of the bridge.
通过预应力斜交板桥的静载试验，结合斜交板桥的理论分析结果，对该斜交板桥的承载力进行了评估。
In a static load experiment, such a method can be used to make estimation in the case that exerted final load can is not up to ultimate bearing capacity.
在静载荷试验中，由于种种原因终止荷载未达到极限荷载时，可用上述方法进行推测。
In this paper, a method, called multinomial regression for forecasting for ultimate bearing capacity of singe pile with static load experiment is proposed.
介绍了一种单桩静载荷试验极限承载力的预测法——多项式回归法。
In this paper, an example of Shawan Bridge static load experiment has been shown to introduce a general way of Short Tower Cable-stayed Bridge static load experiment.
本文以沙湾特大桥为例介绍了矮塔斜拉桥静载试验的一般方法。
By performing a static load experiment on cast-in-place with branches and plates pile, the paper discusses the feasibility of cast-in-place with branches and plates pile in Hangzhou area.
通过挤扩支盘灌注桩静载荷试验，寻求挤扩支盘灌注桩基础在杭州地区应用的可行性。
Simulation and experiment results show its good static and dynamic performance, as well as robustness against system parameter variations and load disturbances.
仿真和试验结果表明该控制策略对系统参数和负载扰动具有很强的鲁棒性，系统动、静态性能良好。
The experiment results showed the static interference effects among these buildings reduced the wind load on each building.
研究了不同体型双塔间的静力干扰效应，顺、横风向和扭转方向的无量纲荷载系数等问题。
The calculated results agree well with experiment data. It is proved that using static state contact arithmetic with ABAQUS software to simulate the pin load distribution is feasible.
分析计算结果与试验结果基本一致，说明采用该软件和静态接触算法来模拟计算钉载分配是可行的。
The calculated results agree well with experiment data. It is proved that using static state contact arithmetic with ABAQUS software to simulate the pin load distribution is feasible.
分析计算结果与试验结果基本一致，说明采用该软件和静态接触算法来模拟计算钉载分配是可行的。
应用推荐