Open the "hot out" valve and let the tank start to fill. It will take probably about 5-10 minutes or so to get 45 gallons into the tank.
当我们打开热水出水阀，水会自然地流入水箱，只要5至10分钟左右，水箱内就能添加45加仑水。
Press the "Start" button, the pump running, then open the suction valve of the pump.
按下水泵“开”按钮，泵即运转；然后打开泵的吸入阀。
Reciprocating pump discharge pipe must be before the start of the valve to open.
往复泵启动前必须将排出管路中的阀门打开。
Should be fully open before the start of suction and discharge pipe valves, non-closing valve started.
启动前应全开吸入和排出管路中的阀门，严禁闭阀启动。
Should be fully open before the start of the suction and discharge pipe valves, non-closing valve to start.
启动前应全开吸入和排出管路中的阀门，严禁闭阀启动。
Open piping attached to a filled tank will not start to drip-leak following installation and test of a Chemtrol Tru-Bloc shut-off valve.
在ChemtrolTru-Bloc关闭阀安装和测试后，连接到满储的储罐的管道开口将不会开始滴漏。
Open piping attached to a filled tank will not start to drip-leak following installation and test of a Chemtrol Tru-Bloc shut-off valve.
在ChemtrolTru-Bloc关闭阀安装和测试后，连接到满储的储罐的管道开口将不会开始滴漏。
应用推荐