The gas pressure and electrical stack temperature of the system can be set at any value required in an actual experiment.
此控制系统的气体压力值和电堆温度值可以任意设定在具体实验要求的某一数值。
Viewed from variable physical and chemical rules of different recipes , the stack temperature sharply rises then slightly drops to room temperature ;
不同氮源种类及配比对发酵温度的影响，表现为堆体的温度先急剧升高并在高温期持续一段时间后缓慢下降至室温；
This stylesheet takes a document containing a number of elements of the form <temperature temp="30"/>, and translates them into a PostScript stack rendering a line graph of those temperatures.
此样式表将获取包含大量 <temperature temp="30"/>格式的元素的文档，并将其转换为呈现温度线图的PostScript堆栈。
Based on the energy conversation of proton exchange membrane fuel cell (PEMFC) stack, the nonlinear temperature model of PEMFC stack with the large range of disturbances is developed.
基于质子交换膜燃料电池电堆的能量守恒，建立了在大范围的负载扰动下电池电堆温度的非线性模型。
The effects of Calender Stack are dependent on materials, working press and uniform temperature upon the roller surface.
轧光机整理效果，很大程度上取决于轧辊辊面材料、轧压力及轧辊辊面温度均匀性。
Proton exchange membrane fuel cell (PEMFC) temperature had great influences on the generation performance of the stack.
质子交换膜燃料电池(PEMFC)温度对发电性能的影响很大。
It is also found that replacement of substrate and adjustment of film stack structure would lead to the change of drift, this will enhance the temperature stability of filter.
同时经过计算分析发现通过更换膜系基板和调整膜系结构可以改变滤光片中心波长的漂移，这个结果有助于提高滤光片的温度稳定性。
The temperature response of stack wall of the power station has been studied by using numerical calculation when the power station is in starting state.
采用数值求解的方法对烟囱在启动工况下壁体的温度响应进行了初步探讨。
Convection heat exchange coefficient, stack size and porosity's influence to the highest temperature in porous media are also discussed in this paper.
计算表明，单基弹药内部最高温度比双基内部最高温度上升的快。 讨论了对流换热系数、堆积尺寸、孔隙率等对弹药内部最高温度的影响。
Through studying the heat-mass transfer and multi-spices electric-chemical reaction, a steady temperature model was developed for molten-carbonate fuel cell stack.
通过研究熔融碳酸盐燃料电池的传热传质和电化学反应机理，根据质能守恒原理建立了电堆的稳态温度模型。
The simulation shows that the highest temperature of co-MCFC stack exists in the middle and outlet;
结果表明顺流型熔融碳酸盐燃料电池堆的最高温度在电堆中间和出口部分；
The temperature changing regularity of slab was studied during stack cooling process by mathematical simulation and field measurement.
针对堆冷过程中铸坯温度的变化规律，采用数学模拟和现场实测方法进行了研究。
On this basis, the temperature control system for this type stack is designed, and the fuzzy-PID fusion control algorithm is used.
在模糊预测函数控制的基础上，建立了一种新型算法来预测高炉铁水硅质量分数。
On this basis, the temperature control system for this type stack is designed, and the fuzzy-PID fusion control algorithm is used.
在模糊预测函数控制的基础上，建立了一种新型算法来预测高炉铁水硅质量分数。
应用推荐