This paper introduces a new design for four axes control system based on ARM and high-speed Pulse Generator.
提出了一种新的基于ARM的嵌入式四轴数控系统的设计。
The EXL is used to control the take-off device by providing a pulse generator to measure line speed accurately for closed loop control.
EXL控制器用于控制拆卸装置的速度，通过脉冲发生器测量不合环路的线速度来实现。
This paper proposes a high speed and low power pulse latch design, and integrates it to high speed DSP address generator.
提出了一种高速低功耗脉冲寄存器的设计方法，并将其应用在高速DSP地址生成单元的设计中。
Based on the analysis of requests to pulse generator of high speed small hole EDM drilling machine, a new combination pulse generator is developed in this paper with modular design method.
分析了高速电火花小孔加工对脉冲电源的要求，研制出一种新型脉冲电源——组合式高速电火花小孔加工脉冲电源。
Aim at the request of STATOM to the trigger pulse generator, USES CPLD to be high speed, the parallel processing ability, designed the STATCOM pulse generator.
针对STATCOM对触发脉冲发生电路的要求，利用CPLD的高速、并行处理能力，设计了STATCOM的脉冲发生器。
Main circuit uses independent RC pulse generator and control circuit can control the main circuit based on 8051 single chip microcomputer and TC4427 high-speed power MOSFET driver.
其主电路采用了独立式RC脉冲放电回路，控制电路则通过8051单片机和TC4427高速MOSFET驱动器完成对主电路的控制。
On the aspect of hardware, they include: narrow pulse and high frequency ultrasonic sensor's design, high frequency signal generator and receiver's design, high speed data completed sampling's design.
因此本文还详细阐述以下内容：硬件方面采用了高频窄脉冲信号发生及接收放大电路、高速数据采集电路；
A high voltage, high speed, and high repetition rate pulse generator solves the high pulse repetition rate limitations associated with RF power amplifiers.
一种高电压、高速、高脉冲重复率脉冲发生器，解决了与RF功率放大器相关联的高脉冲重复率限制。
As the important part of data acquisition system, high-speed pulse signal generator is commonly used in self-detection and test of the system.
高速脉冲信号源是数据采集系统的重要组成部分，常用于系统的自检与测试中。
As the important part of data acquisition system, high-speed pulse signal generator is commonly used in self-detection and test of the system.
高速脉冲信号源是数据采集系统的重要组成部分，常用于系统的自检与测试中。
应用推荐