Applying the concept of the solid Angle, this paper generally demonstrates the Ampere circuit rule.
本文应用立体角的概念，一般地证明了安培环路定理。
The solid angle for a disc source parallel to a disc detector has been determined using a one dimension integral.
本文给出了圆面探测器对圆面源的几何因子的一元积分形式。
It was found that the coherent length became shorter and the spectrum resolving power became lower as a result of solid Angle produced by the extended light source.
分析表明，扩展光源存在的立体角导致系统的相干长度变短，光谱分辨率降低。
We solved at the same time a pure mathematical problem by physical procedure i. e. calculating the solid angle subtended by a circular plate to any point in the space.
同时，用物理学方法解决了圆盘面对空间任意点所张的立体角的计算问题。
A computing method of coefficient matrix is given. For a few special points including singular points, the numerical values of solid Angle of a cylindrical bottom surface open to these special points.
对包含奇异点在内的几个特殊点给出了柱底面对这些点所张立体角的值，并给出了电测井积分方程系数矩阵的计算方法。
The effect of Angle of inclination at the interface of a viscous fluid and thermoelastic micropolar honeycomb solid due to inclined load is investigated.
研究倾斜荷载作用在黏性流体与热弹性微极蜂窝结构固体界面上时，荷载倾斜角的影响。
A problem about tubing string vibration caused by the fluid unsteady flow inside tubing string is studied from the Angle of solid liquid coupling vibration in dynamics.
文章从动力学中固液耦合振动的角度出发，研究了油管柱内流体不稳定流动引起的油管柱振动问题。
Angular stiffness and elastomer shear strain on maximum swinging Angle are important indexes in flexible joint design of solid rocket motor.
角刚度(又称弹性比力矩)及弹性件在最大摆角下的剪切应变是固体发动机柔性接头设计的重要指标。
Contact Angle is one of the handiest and most widely used methods, which are used to identify solid surface.
接触角是最方便、应用最广泛的表征固体表面的标准方法之一。
The roughness of the solid surface has little influence on the dynamic contact Angle.
固体表面粗糙度对动态接触角的影响不大。
The ports are designed to prevent liquid drops or airborne solid particles from entering the housing when introduced at any angle greater than 60 degrees downward from vertical.
该端口设计防止任何大于60角度的液体滴漏和固体颗粒进入电机。
Variable Angle spiral method was used in a trial way in the design of the warped blader of solid - liquid two phase slurry pump.
采用变角螺旋线法对固液两相流渣浆泵扭曲叶片进行了尝试性设计，并初步总结了其设计方法和规律。
The pressure distribution curve and the influence of the angle of head are tested and analyzed using steel ball qua solid granules pressure-carrying medium through experiments.
测试分析了钢球作为固体颗粒传压介质的压力分布及压头锥角对压力分布的影响规律。
In laboratory experiments, the expansion Angle and impact area of gas-solid two-phase jet, distribution of the central and outer jer flow as well as the influencing factors were measured.
试验中测定了气—固两相流的射流膨胀角及冲击面积，探讨了中心射流与外层射流的分布及其影响因素。
The output parameters such as beam divergence angle in far-field output power of high power solid state lasers are variable due to thermal effect of optical pumping.
由于光泵浦热效应，高功率固体激光器的输出参数如光束远场发散角、输出功率等会发生变化。
The'standard' massive flow silos designed with certain half vertex angle was only suitable for a little part of particulate solid.
指出在一定半顶角下设计的“标准”整体流料仓，只适用于很小一部分粉体物料。
Plated frame, high backrest, adjustable backrest Angle, after bending handrails, lift foot care, solid front, pneumatic rear wheel plastic wheel frame, folding handle support.
电镀车架，高靠背，可调靠背角度，后折弯扶手，升降脚托，实心前轮，塑料轮框充气后轮，可折支撑把手。
Spray frame, high backrest, adjustable backrest Angle, after the folding armrest, lift foot care, solid front, solid rear tire.
喷塑车架，高靠背，可调靠背角度，后折扶手，升降脚托，实心前轮，实心胎后轮。
The effect of multi transversal mode on quadrature frequency conversion in a solid-state laser was analyzed, and the relation between the conversion efficiency and the divergent angle was conducted.
对多横模全固态激光器使用正交频率变换进行了分析，计算了频率转换效率与激光发散角的关系。
Effects of inclined Angle on semi-solid microstructure of hypoeutectic high cr cast iron prepared by inclined plate cooling method were investigated.
采用倾斜板冷却体法对亚共晶高铬铸铁进行半固态成形，研究了倾斜板角度对亚共晶高铬铸铁半固态组织的影响规律。
The results show that envelop of solid waste can be simulated by double lines, and that the cohesion and friction angle are dependent upon whether or not the solid waste is rolled.
研究结果表明：垃圾土的强度包线可以用双线强度包线来表达，黏聚力和内摩擦角取决于是否填埋碾压；
The results of experiment have shown that gas pendulum can be utilized to measure the acceleration and tilt angle as same as solid pendulum and liquid pendul…
试验结果表明，与固体摆、液体摆一样，利用气体摆原理亦能检测加速度和倾角。
By using 3d solid model, the twist-back Angle of steam turbine twisted long blade with integral shroud was analyzed and calculated.
采用三维实体模型，对自带围带的汽轮机扭曲长叶片的扭转恢复角进行了计算分析。
In laboratory experiments, the expansion Angle and impact area of gas-solid two-phase jet, distribution of the central and outer je...
试验中测定了气—固两相流的射流膨胀角及冲击面积，探讨了中心射流与外层射流的分布及其影响因素。
In laboratory experiments, the expansion Angle and impact area of gas-solid two-phase jet, distribution of the central and outer je...
试验中测定了气—固两相流的射流膨胀角及冲击面积，探讨了中心射流与外层射流的分布及其影响因素。
应用推荐