Then Columbus took the egg and struck its small end gently upon the table so as to break the shell a little. After that there was no trouble in making it stand upright.
于是哥伦布拿起那只蛋，把尖的一头轻轻往桌上一磕，敲碎一点蛋壳，这样就毫不费力地使鸡蛋笔直地立在桌上。
The conical stator has a small end and a big end.
圆锥形定子具有小端和大端。
This small end fits inside the bottom of the piston.
小头装在活塞的底部。
The connecting rod links its large end to the crankshaft and its small end to the piston.
连杆的大头与曲轴连接，小头与活塞链接。
Then Columbus took the egg and struck its small end gently upon the table so as to break the shell a little.
于是，哥伦布拿起鸡蛋，将相对较小的那一端在桌子上轻轻一磕。
Then Columbus took the egg and struck its small end gently upon the table so AS to break the shell a little.
于是哥伦布拿起那只蛋，把尖的一头轻轻往桌上一磕，敲碎一点蛋壳。
The connecting rod is attached to the crankshaft at one end (big end) and to the piston at the other end (small end).
连杆一端(大头)与曲轴相连，另一端(小头)和活塞配合。
The result has shown that the fracture was caused by such surface defects as fold crack in section a at connecting rod small end.
结果表明，断裂由连杆小头A截面的表面缺陷(折叠裂纹等)引起。
NIB : Green roller defect on the small end radius; caused by taper die failure. A sharp protrusion on the small end of the roller.
由于圆锥模具缺陷造成的半成品滚子小端倒角缺陷， 滚子小端有尖锐的突出。
A novel ceramic screen plate comprises a plate body and suction tubes, and the plate body is composed of a functional plate, a sloping side, a big end, and a small end.
一种新型陶瓷过滤板，包括滤板体和抽滤导管，板体分为功能面，斜边，大端，小端。
Then theoretical resonance length, small end diameter, displacement node, magnification factor, shape factor and other parameters of the amplitude amplifier pole could be determined.
确定出其理论共振长度、小端直径、位移节点、放大系数、形状因数等参数。
Decentraction of the conn-rod small end hole center with the excircle center of the conn-rod small end hole blank, which causes the hole wall of one side getting thin with the strength dropping.
连杆小头孔中心与连杆小头孔毛坯外圆中心不同心，使一边孔壁变薄，强度下降。
Decentraction of the conn-rod small end hole center with the excircle center of the conn-rod small end hole blank, which causes the hole wall of one side getting thin with the strength dropping.
连杆小头孔中心与连杆小头孔毛坯外圆中心不同心，使一边孔壁变薄，强度下降。
应用推荐