In the case of FDDI, the FC field is placed in the Least Significant Byte of this field.
在FDDI的情况下，FC字段被放置在这个字段的最低有效字节中。
Big-endian means that the most significant byte has the lowest address (the word is stored big-end-first).
big -endian意味着最高位字节存储在最低地址(按高位优先的顺序存储字)。
Little-endian means that the least significant byte has the lowest address (the word is stored little-end-first).
而little -endian意味着最低位字节存储在最低地址(按低位优先的顺序存储字)。
Encoding ELFDATA2MSB specifies 2's complement values, with the most significant byte occupying the lowest address.
ELFDATA2MSB编码指定了2的补数值，最大有意义的字节占有最低的地址。
Encoding ELFDATA2LSB specifies 2's complement values, with the least significant byte occupying the lowest address.
ELFDATA2LSB编码指定了2的补数值，最小有意义的字节占有最低的地址。
Basically, the first word is the preferred word, and then the other alignments are on the least-significant byte or halfword of that word.
基本上，第一个字就是首选字，而其他字对齐到最低有效字节或半字上。
The most significant byte (MSB) specifies the token type and consequently identifies the abstraction and its associated metadata table.
最有意义的字节(MSB)指定了标记类型，因此用于标识抽象及其关联的元数据表。
When you cast the integer into a single byte, only the least significant byte (0x00 to 0x7f) will be copied as a hex value to the single-byte array.
将这个整数造型为一个单字节时，只有最低有效位字节（0x00到 0x7f）会作为十六进制值拷贝到单字节数组。
Big-endian means that the most significant byte is stored at the lowest memory address and the least significant byte is stored at the highest memory address.
Big -endian是将高位字节存储在内存的低地址中，将低位字节存储在内存的高地址中。
Little-endian means that the least significant byte is stored at the lowest memory address and the most significant byte is stored at the highest memory address.
Little - endian是将低位字节存储在内存的低地址中，将高位字节存储在内存的高地址中。
That is to say, on the x86 system, the least-significant byte (the smallest values) are stored in the first byte of ll; on the Power Architecture system, they're stored in the last.
这就是说，在x86系统上，最低位字节(最小值)首先存储在ll的第一个字节中；在PowerArchitecture系统上，它们则存储到最后。
Count the number of ones in each byte of the 8-byte block; if the number of ones is even, make it odd by setting the least significant bit to one.
统计8字节块中每字节中的1的个数，如果1的个数为偶数，那么就设置最低位为1使它成为奇数。
If the number of ones in a byte is already odd, you will set its least significant bit to a zero.
如果一个字节中1的个数已经为奇数，那么就将它的最低位设置为零。
Remember, the LQD instruction only loads from 16-byte boundaries. It will therefore ignore the four least significant bits during the load, and just load an aligned quadword from memory.
记住，lqd指令只能从16字节边界加载，所以它会在加载期间忽略最低有效的四位，而只会从内存加载已对齐的四字。
The least significant bit of the cmd byte is the phase indicator, which is used to differentiate a new command from the retransmission of an old one.
命令字节的最小位是相位指示器，是用来区分一个新的命令还是老命令的重传。
Moreover, compatibility with other single-byte encodings is another significant challenge.
此外，与其他单字节编码系统的兼容性也是一个巨大的挑战。
Moreover, compatibility with other single-byte encodings is another significant challenge.
此外，与其他单字节编码系统的兼容性也是一个巨大的挑战。
应用推荐