Measuring Chain Settings:the signals to be measured(measuring chain)are displayed with the most important parameters in this dialogue.
测链设置： 在此对话框中显示了待测量的信号（测链），并列出了其最重要参数。
Based on the features of signals to be measured, the corresponding signal conditioning circuits are designed with the components of ultra-low noise and low distortion.
根据待测信号的特点，选用超低噪声、低漂移元器件，设计了相应的信号调理电路。
There are many kinds of air-borne equipments and the signals to be measured are complex, it is hard to attain the goal of fault diagnosis and isolation just use one method.
由于运八系列飞机上装备的机载设备种类比较多，测试信号复杂，单纯使用一种故障诊断方法很难达到故障诊断与隔离的目的。
Frequency of external signals is constantly needed to be measured when complex measurement and control instructions are executed in an embedded system.
嵌入式控制系统在执行复杂测量与控制任务的同时，常需要测量外部信号的频率。
In the testing of a certain antiaircraft artillery servo system, the signals needed to be measured are time-invariant signal and time-varying signal.
在某型高炮随动系统的测试中，待测信号有非时变信号和时变信号两种。
The phase difference often needs to be measured between two signals with the same frequency in power system, such as power voltage and power current signals.
在电力系统中常常需要对两个同频率信号(如工频电压和工频电流)之间的相位关系进行准确的测量。
This 4-electrode design is able to produce two separate signals which allow two gases to be measured with one sensor.
这种四电极设计使得一个传感器能够同时测量两种气体并且输出两种不同的信号。
After the power spectrum estimation for the collected signals, the measured objectives 'scattering coefficient can be calculated out combined to the radar parameters and environmental parameters.
对采集到的信号做功率谱估计后，结合测量时的雷达参数和环境参数，就可以计算出被测目标的散射系数。
After the power spectrum estimation for the collected signals, the measured objectives 'scattering coefficient can be calculated out combined to the radar parameters and environmental parameters.
对采集到的信号做功率谱估计后，结合测量时的雷达参数和环境参数，就可以计算出被测目标的散射系数。
应用推荐