Shortwave non-orthodox frequency-hopped signal selection by improved time correlation arithmetic is introduced.
介绍了利用改进型的时间相关算法进行短波非正交跳频网台信号分选的方法。
Because the RGA computation is implemented based on the residue analysis, the proposed method can effectively reduce computational complexity and shorten signal selection process.
由于是在留数分析的基础上进行RGA计算，因此，这种调制信号选取方法可有效降低计算量和缩短选取进程。
To solve these problems, a modified method is presented, which subdivides the voltage vector sectors and switching signal selection table, and optimized stator flux compensating voltage.
针对上述问题，给出了一种通过细化电压矢量合成扇区和开关信号选择表，优化定子磁链补偿电压的改进方法。
The method that widened tracking gate was always used to deal with PRF jitter radar in the modern signal selection technology, but it would result in some exclusive signal in the wide gate.
在现代信号分选技术中对付重频抖动雷达的方法主要是加宽跟踪波门，这样会使宽波门内出现异部信号。
Simulation results show that the selection of reference signal depends not only on the correlation , but also on the distribution of vibration energy, which can be used to guide the signal selection.
仿真结果表明，参考信号的选择不仅与信号的相关性有关，还与振动信号的能量分布有关，为选择振动信号作为参考信号提供了依据。
This chapter will focus on basic signal theory and then on the selection and configuration of modular data acquisition hardware.
本章我们重点学习基本的信号理论和数据采集硬件模块的选择和配置。
On the base of hardware approach, to discuss all the theory involve in active detecting sonar system, including the selection of signal waveform, digital signal sampling, digital signal processing.
以硬件为基础，对所涉及到的理论都作论述，包括探测声纳的信号波形选择，数字信号采样、处理原理与方法。
At last, the paper also presents three different applications of the sorting processor to electronic warfare: detection of threating signal, filtering of useless signal and PRF selection filtering.
最后介绍了分选预处理器在电子战中的三种应用：威胁信号检测、无用信号滤波和脉冲重复频率选择滤波。
Selection criterion is based on the Frobenius-2 norm of received signal vector at each receiving antenna.
该文只考虑了接收天线选择，天线选择的准则是基于每个天线接收到的信号向量F-2范数。
In the section of hardware design, selection of the CAN bus communication interface card, design of CAN nodes and the signal acquisition system are introduced.
在其硬件设计中，着重介绍了CAN总线通讯接口卡的选择、CAN节点设计与信号采集系统设计。
The problems about the selection of excitation signal, limits of measurement frequency and noise influence have been discussed.
最后还讨论了时域法测量电极阻抗的激励信号的选择、测量频率上、下极限和噪声影响等问题。
Two main issues were investigated: a) the identification time for road input condition; b) the selection of reference signal on which the control gain are tuned.
主要对路面输入变化的估计时间和用以决定控制增益变化的系统输出信号的选择进行了研究。
Details of the sensor's structure, its working principle, the selection of working mode as well as the signal processing circuit is presented.
详细介绍了传感器的结构、工作原理、工作模式的选择以及信号检测电路。
Input channel selection, gain Settings and signal polarity can be configured in software using the bidirectional serial port.
利用双向串行端口，可在软件中进行输入通道选择、增益设置和信号极性配置。
Introduced the signal grounding patlems, the selection of grounding points and so on.
本人介绍了信号接地方式以及接地点的选择等内容。
The polluted voltage signal was denoised in the case, and the results show that threshold selection is directly related to the quality of de-noising.
在例子中对染噪的电压信号进行消噪处理，结果表明阈值的选取直接关系到消噪的质量。
The design identify shutting of key using row scanning. It is peculiar in a-side of keys selection and signal transmission.
设计中采用行扫描法识别键的闭合，并且在按键的选用和信号的传输上都有其独特之处。
In this paper the algorithm selection of maximum entropy spectral estimation circuit in digital signal processing system is investigated.
本文针对数字信号处理系统中最大熵谱外推电路的算法选择进行了研究。
A selection signal that is active when data are correct on a bus.
当总线的数据正确时，使之工作的一种选择信号。
Because magnetic memory signal is faint, selection of magnetic sensor is very important.
磁记忆信号非常微弱，磁敏传感器的选择十分重要。
The selection of filter is controlled by software, so that low-noise signal can be acquired in a wide frequency band.
由软件控制选择滤波器，这样可以在很宽的频带获得低噪声的信号。
This article elaborates signal transmission, selection of insulators for hydrometric cableway of Yifeng hydrological station in Jiangxi.
阐述了江西省宜丰水文站在水文缆道信号传输方面，绝缘子选择上的一些做法。
In this paper we introduced the speech signal feature parameters, the speech signal feature parameters selection, and introduced short-term energy, short-term average range extraction.
本文对语音信号特征参数、语音信号特征参数的选择进行了介绍，并介绍了语音信号的短时能量、短时平均幅度的提取。
The instable signal is abnegated and the steady signal is intercrossed for improving the precision through constructing adaptive function and the process of genetic selection.
通过构建适应度函数，根据信号适应度函数进行遗传选择，舍弃不稳定信号，对有用信号进行杂交，从而获得较高的定向精度。
The result shows that in order to obtain the strong echo signal, a suitable selection of the ultrasonic transducer operating frequency is necessary.
由此表明，选择合适的声发射换能器，有助于提高液位检测回波信号的强度。
The demodulator has two main parts, hardware and software. It can perform channel selection and signal demodulating using it's own keyboard or the PC connected.
它由硬件和软件两大部分组成，通过自带键盘或上位机可实现频道选择和信号调节。
The selection of the optimal threshold of signal detection.
信号检测的最佳门限选择；
Selection of proper parameters on the basis of this conception to sample the signal can realize the phase correlation between the sampling signal and the measured signal.
利用这一概念选取合适的采样参数对测量信号进行采样，可实现采样信号同待测信号相位相关。
The selection of different software-hardware combination schemes makes it possible to improve measurement accuracy and rang, and different accuracy for different signal segments can also be achieved.
选择不同的硬软件配合方案，提高了信号的测量精度，并扩大了测量范围，可对信号的不同区段选择不同的测量精度。
It can work in ei - ther an equal-gain combining mode or a selection mode adaptively according to the ratio between the signal levels in the two branches.
它可根据两支路信号电平之比值来自适应地或是工作于等增益合并模式，或是工作于选择分集模式。
应用推荐