The product can also be used for general analog signal isolation applications requiring high accuracy, stability and linearity under similarly severe noise conditions.
该产品也可用于一般模拟信号隔离的应用要求精度高,稳定性和线性下同样严重的噪声条件。
Output switch module is a low voltage PLC internal drive external signals into the switching signal output device and to achieve internal and external PLC electrical signal isolation.
开关量输出模块是将PLC内部低电压信号转换成驱动外部输出设备的开关信号,并实现PLC内外信号的电气隔离。
The paper also introduces software process and code based on fore methods and adopts 6N137 as signal isolation to solve outside interference weakness under mine environment based on CAN Bus.
在此基础上,设计了软件流程和代码。基于CAN总线在矿井环境下容易受到外界干扰的弱点,使用6N137进行信号隔离。
The problem of antijamming must be considered in designing and developing computer control systems and intelligent devices. The signal isolation is an important meathod to reject interference.
计算机控制系统的设计与智能仪表的研制开发必须要考虑抗干扰问题,信号隔离是抗干扰的重要措施。
The novel structure not only realizes the complete isolation of the sensitive elements from the signal processing circuits, but also sufficiently improves the stability and the sensitivity.
这种结构既方便地实现敏感元和信号处理电路的完全隔离,又有效地改善了敏感特性和稳定性。
Master clock photoelectric isolation measures can be used to ensure that the input signal will not be because of factors external to the host and cause interference and damage equipment.
母钟设备可以采用光电隔离措施,保证不会因为外部输入信号的因素而对主机设备造成干扰和损害。
Aiming at the noise jamming problems in acquisition of small current signals, an isolation and acquisition board for current signal is designed based on HCNR201 high-linearity analog optical coupler.
针对电流小信号采集中存在噪声干扰的问题,采用高线性度模拟光耦hcnr 201设计了电流信号隔离采集板。
In view of these, the authors give here a comprehensive commentary on some common techniques in mutant isolation, enzyme assay and signal detection and their progress recently.
居于此,文中综合评述在突变株分离、酶检测和信号探测等方面,目前的一些常用技术及其最新进展。
Weak pulse signal, sensitive, vulnerable to interference, in order to eliminate the noise pulse test, the isolation circuits and multiple filter circuit design.
脉搏信号微弱、敏感、易受干扰,因此为了消除脉搏测试中的各种噪声,设计了隔离电路和多重滤波电路。
For hardware design, RC filter, voltage sensitive resistor and photoelectric isolation method are used to eliminate interference signal in sampling channel and A/D channel.
在硬件方面,采用RC滤波器、压敏电阻、光电隔离等措施,消除了采样通道及A/D通道的干扰信号;
Using a unique high-speed magnetic isolation digital sensor to directly collect the signal of input voltage and current, ensure the data reliability and security.
仪器采用独特的高速磁隔离数字传感器直接采集输入的电压、电流信号,保证了数据的可靠性和安全性。
It USES a unique high-speed magnetic isolation digital sensor to directly collect the signal of input voltage and current, ensure the data reliability and security.
仪器采用独特的高速磁隔离数字传感器直接采集输入的电压、电流信号,保证了数据的可靠性和安全性。
A jamming signal based on this method is constructed, and at the same time a blue print is given which shows how to realize the isolation between receive and transmitter of a jammer by this method.
使用该方法构建了干扰信号,同时给出了采用该方法实现干扰机收发隔离的电原理框图。
Photoelectric isolation is an important measure of system anti-jamming, and it is widely used in the signal processing biomedicine engineering. But signal linear isolation is rarely reported.
光电隔离是系统抗干扰的一种重要措施,在生物医学信号的抗干扰中被广泛应用,但信号的线性隔离却少有报道。
Transmitter-Receiver isolation is a kind of technology to ensure the receiving of the radar signal and don't produce transmit-receive self-excitation when the jamming transmit noise.
保证在干扰发射时对雷达信号的正常接收(对干扰信号具有一定的抑制比),不产生收发自激且保证具有一定的接收信号质量称为收发隔离。
GX-1Exploding isolation type drawing signal switch used for mining is applicable to coal mine where has explosive gas and coal dust.
GX-1矿用隔爆型拉引信号开关适用于具有煤尘和爆炸性气体的煤矿井下,作为低压开关防爆电铃或其它小型声响设备。
Methods are put forward which are used for unorthodoxy placement gyro fault detection and isolation when the three gyros have trouble by the attitude signal.
提出了利用姿态角传感器在非正交配置的陀螺仪发生三个以上的故障时进行故障检测与隔离的方法。
Based on node isolation principle, it adopts pre emphasize technique to equilibrate the EDFA output power of all signal channels.
它以节点孤立原则为基础,采用预均衡技术对经edfa放大后的所有光信道功率均衡。
Analog signal linear photo-isolation is carried out by using voltage-frequency conversion and frequency-voltage conversion technique so as to effectively overcome nonlinearity of the photocoupler.
采用电压频率变换和频率电压变换技术处理模拟信号,有效的克服了光电耦合器的非线性,实现了模拟信号的线性光电隔离。
Analog signal linear photo-isolation is carried out by using voltage-frequency conversion and frequency-voltage conversion technique so as to effectively overcome nonlinearity of the photocoupler.
采用电压频率变换和频率电压变换技术处理模拟信号,有效的克服了光电耦合器的非线性,实现了模拟信号的线性光电隔离。
应用推荐