The goods for longer periods of time for casting hypoeutectic AL-Si alloy modification.
本品用于浇注时间较长的亚共晶铝硅合金的变质处理。
The Al-si Alloy modified by tellurium is an ideal material for making high gastight castings.
经碲变质处理的铝硅合金是制造高气密性铸件的理想材料。
Based on the greenness idea, the greenization planning on the hypoeutectic cast Al-Si alloy is provided.
根据绿色化思想，对铸造亚共晶铝硅合金进行了绿色化规划探讨。
Al Si alloy was widely used because of its good properties, Iron is the most common impurity in al Si alloy.
铝硅合金因其具有优良的性能而得到了广泛地应用，铁相是铝硅合金中最为常见的杂质。
Morphology transformation of eutectic silicon in Al-Si alloy during solid solution was observed by OM and SEM.
通过金相和扫描电镜观察研究了铸造铝硅合金中的共晶硅在固溶热处理过程中的形态变化。
The modifying experiments on hypereutectic Al - Si alloy were made by addition of sodium flux and P - Cu alloy.
用磷铜合金和四元钠盐变质剂对过共晶铝硅合金进行了变质处理试验。
The dimension stability of hyper eutectic Al Si alloy piston is higher than that of eutectic Al Si alloy piston.
过共晶铝合金活塞的尺寸稳定性高于共晶铝合金活塞；
The preparation of hypoeutectic Al-Si alloy billets for semisolid forming by low temperature casting was studied .
研究了低温铸造法制备亚共晶铝硅合金半固态成形用坯料。
Study is made on the influence of electromagnetic field on iron-rich phase of the Al-Si alloy with Mn as de-ironing additive.
文中以铝硅合金中的富铁相杂质颗粒为分离对象，利用流动试验研究了磁感应强度、分离通道截面形状和金属熔体回路尺寸对分离效率的影响。
The coarse Al-Si alloy produced by carbon thermal reduction of aluminous ore includes 55% aluminum, 25% silicon and some impurities.
由电热还原法制取的一次铝硅合金含有铝55%，硅25%和一些杂质。
The influence of side-introduced power ultrasonic treatment on the solidification characterization of ZL102 Al-Si alloy was discussed.
研究了功率超声处理对ZL102铝硅合金凝固特性的影响。
The crown diameter of eutectic al Si alloy piston has increased suddenly in twice, but the hyper eutectic al Si alloy piston only once.
共晶铝硅合金活塞顶部直径有两次突然长大，而过共晶铝合金活塞仅有一次。
The results show that graphite with good corrosion resistance can protect the heat-exchange tube from the corrosion of molten Al-Si alloy.
结果表明，石墨良好的抗腐蚀性将保护换热管不受熔融铝-硅合金的腐蚀。
According to the practice, the paper analyzes washing lime and chromite, and introduces the means of tunning Cr-Si alloy after washing furnace.
通过生产实践，对用石灰和铬矿洗炉进行了分析，并介绍了洗炉后转炼硅铬合金的方法。
Modification mechanism and existing form of Sb and Mg in Al-Si alloy were studied by using optical microscope and scanning electron microscope.
采用金相和扫描电镜分析研究了锑、镁在铝硅合金中的存在形式和变质机制。
The porosity of porous Al-Si alloy is 40~80% and percentage of open-cell is above 85%, bom of which vary with the fabrication process of preform.
孔隙率在40～80%，孔隙连通率在85%以上，孔隙的大小和孔隙率取决于预制块的制备工艺。
There are a great many of Al-Si alloy grades at present., for example, 11 grades in China, 14 grades in USA, 16 grades in Russian, 11 grades in Japan.
现有的铝硅合金牌号过多，以铸造亚共晶铝硅合金为例，中国至少有11种牌号，美国有14种，俄罗斯有16种，日本有11种。
The results of electrochemical experiments and moisture and hot experiments indicate that the electrolytic Al - Si alloy has excellent corrosion resistance.
电化学试验和湿热试验结果表明电解铝硅合金具有良好的耐蚀性。
The result indicated that: 1. P-RE combination modification can modify both the eutectic Si and primary Si of the hypereutectic Al-Si alloy at the same time.
研究结果表明：1. P - RE复合变质对过共晶铝硅合金的初晶硅和共晶硅都具有良好的变质和细化作用。
The morphology of Si phase has a remarkable effect on mechanical properties of Al Si alloy by quantitative metallographical measurement and regression analysis.
通过定量金相测量及回归分析，硅相的形态对合金的力学性能影响显著。
Hypereutectic Al-Si alloy with the quality of low density, good heat stability and high wear-resistance, is an ideal wear-resistant and heat-resistant material.
过共晶铝硅合金具有低密度、良好的热稳定性和高耐磨性，是一种理想的耐磨耐热材料。
On the two materials, Al-Si alloy has greater platform stress and long platform region, the overall compression performance of Al-Si alloy is better than pure Al.
对上述两种材质而言，铝硅合金平台应力值较大，且平台区域较长，铝硅合金的压缩性能整体高于纯铝。
This paper introduces the design of hardware and software of a thermal-analysis meter for measuring Al-Si alloy modification effect, and discusses its application.
介绍了测量铝硅合金变质处理效果用热分析仪的硬件、软件设计及实际应用。
The results show that the higher the rotating speed of centrifugal casting machine with magnets is, the finer and more uniform the microstructure of Al-Si alloy is.
结果表明，在安装磁铁情况下，离心机转速越高，铝硅合金的组织越细小均匀。
Hypereutectic Al-Si alloy which has small proportion, low coefficient of thermal expansion, good wear resistance and dimensional stability is an ideal piston material.
过共晶铝硅合金比重小、热膨胀系数低、耐磨性和体积稳定性好，是理想的活塞材料。
A kind of polishing agent PPG-1 with cost-effective and high performance suitable for Al-Si alloy products was developed based on spiral vibration polishing processing.
针对铝硅合金制品的螺旋振动抛光工艺进行了研究，开发了一种成本低廉、性能良好的新型抛光剂PPG - 1。
The method of determination of silicon in Mn - si alloy with potassium fluosilicate titration is introduced. On the best test condition, disturbance element is removed.
介绍了用氟硅酸钾滴定法测定硅锰合金中硅的方法，选择确定了最佳实验条件以及干扰的消除。
The worn layer of Al-Si alloy where only wear debris are going to delaminate is composed of composite layer, deformed layer and undeformed parent material from the surface to the inside.
即将发生粒子剥落的铝硅合金磨损表面区域，由表及里为复合层、变形层相未变形母体材料。
It introduces a new technology of producing Ca-Si alloy. The experiment showed that this process can gain better results, long smelts campaign, low power consumption and high productivity.
介绍了硅钙合金生产新工艺。实践表明，采用碳硅热法冶炼硅钙合金可降低电耗，延长冶炼周期，有显著的经济效益。
In this paper, the properties and preparation of ceramic short fiber reinforced al si alloy matrix composite and it is application to the piston of internal combustion engines are reported.
本文报导了陶瓷纤维增强复合材料的性能、制备研究及其在内燃机活塞上的应用。
应用推荐