However, further increasing of re content would degrade the shear properties of the lap joint.
而当稀土含量进一步增加时，焊点的强度及塑性均下降。
The shear properties indexes of brown rice grain are important in evaluating quality of brown rice.
稻米籽粒的剪切特性指标可以用来评价稻米的品质。
The tensile and shear properties of F-12 aramid fiber and carbon fiber intem1y hybrid NOL ring composites are presented in this paper.
本文以NOL环研究了F- 12／碳纤维混杂复合材料的拉伸性能和剪切性能。
In this paper, shear properties of 3-d braided composites and C-L fiber reinforced composites after moisture absorption behaviors are studied.
本文对三维四向编织复合材料和长碳纤维复合材料吸湿后的剪切性能进行了研究。
The text introduces performance of bending components, shear properties, as well as in the use of performance under load, and dynamic performance.
介绍了受腐蚀钢筋混凝土受弯构件的性能、抗剪性能、以及在使用荷载作用下的性能和动力性能。
The simple shear tests are conducted to study the shear properties of silty clay-concrete interface by using the improved cyclic simple shear testing system.
利用改进的循环单剪试验系统进行粉质黏土—混凝土接触面剪切性能试验。
The parameters of impact elements are analyzed to find out their influential regulation of the shear properties of the concrete components which have near-surface mounted the steel plate.
通过分析试验结果和有限元模拟，得出以下结论：①普通嵌贴钢板的极限抗剪承载力较高，破坏形态为混凝土拉剪破坏，属于脆性破坏。
The tensile shear properties, mass loss ratio and surface residual stress of the bond samples before and after the thermal cycling were measured. The tensile shear fracture morphologies were observed.
测试了热循环前后胶接试样的拉伸剪切性能、质损率和表面残余应力，观察了拉伸剪切断口形貌。
Absorbency properties in the fabric help keep the skin dry and cool, providing further protection against friction and shear.
纤维的吸水特性有助于保持皮肤干爽凉快，为避免摩擦力和剪应力的伤害提供了进一步的保护。
Shear strength and shear strain are the basic properties in mechanics of concrete. They also serve as important data for finite element and failure criterion research on concrete.
抗剪强度和剪切变形是砼的基本力学性能，又是强度理论研究和有限元分析的重要数据。
Soil shear wave velocity is an important parameter which influence the dynamic properties of soil, and it is widely used in engineering practices.
土层的剪切波速是反映土体动力特性的重要参数。
The testing method and the data analysis in this paper provide a reference for cyclic simple shear tests on dynamic properties of soil.
本文的试验方法和数据分析对使用循环单剪试验研究土的动力特性有较好的参考作用。
The results show that proper pressure and interlayer thickness can evidently improve the microstructure and mechanical properties, and the shear strength of joint is increased with the holding time.
结果表明：合适的压力和中间层厚度能有效改善接头的组织和力学性能，接头剪切强度随保温时间延长而提高。
The micro shear test could give a new way to evaluate the mechanical properties in weld joint of aluminium alloy.
微型剪切试验为铝合金焊接接头力学性能的评定提供了一个新途径。
The results show that the coatings with good application properties have larger apparent viscosity , higher yield stress , lower plastic viscosity and proper thixotropy at lower shear rate.
实验结果表明，使用性能良好的锭模耐火涂料在低剪切条件下，应具有较大的表现粘度与屈服应力，以及较小的塑性粘度和适当的触变性。
The viscosity is one of the most important flow properties of blood, the blood is a non-Newtonian fluid. the viscosity of blood is change with the shear rate changes.
粘滞度是血流最重要的性质之一，血液是非牛顿流体，血液的粘度随着切变率的变化而变化。
The results indicated that transverse shear effect affects greatly on the bending properties of the plank while the ratio of span-height was small.
结果表明：在跨高比较小时，横向剪切效应对板的弯曲性能有显著影响；
The study shows that grass charcoal earth has properties such as high natural porosity ratio, high moisture content, high compressibility and low shear strength etc.
研究表明草炭土具有高天然孔隙比、高含水率、高压缩性和低抗剪强度等性质。
The tensile compressive shear and impact properties of carbon fibre are tested.
用碳纤维进行了性能研究，测试了拉伸、压缩、剪切和冲击性能。
In this paper, properties of automobile gear oil used different viscosity improvers, such as viscosity, brookfield viscosity, low temperature fluidity, shear stability, etc. are studied.
本文就粘指剂在车辆齿轮油中的应用进行了考察，结果显示不同粘指剂在应用过程中对油品的低温性能、增粘效果、剪切安定性等形成不同的影响。
According to the test, the Steel-Fibre Reinforced concrete has good properties, such as stretching, shear resistance, cracking resistance, earthquake resistance and so on.
试验表明，钢纤维混凝土具有优良的抗拉、抗剪、抗裂、抗震等性能。
In this paper, by combining in-situ fibrillation with shear force field together to enhance their reinforcement ability, the properties of the composite are expected t.
原位成纤作为一种重要的提高聚合物复合材料力学性能的方法而受到广泛关注。
Influence of CVD and LIC densification processes on mechanical properties, especially interlaminate shear strength(ILSS) of carbon cloth reinforced 2D C/C composites is studied.
研究了液相浸渍及化学气相法致密工艺对二维炭炭（2DC C）复合材料力学性能的影响，尤其是对层间剪切强度（ILSS）的影响。
When other conditions are the same, compare to weaker shear force, stronger shear force leads to better mechanical properties, particularly at low PHE content.
当其他条件相同时，与弱剪切作用相比，强剪切作用下制备的共混物的力学性能更好，特别是当PHE含量较低的时候。
In-plane and out-of-plane mechanical properties of masonry cavity shear wall have been researched in this paper with financial support from Changsha New wall Material Office.
受长沙市新型墙体材料办公室的委托，本文进行了配筋混凝土砌块复合节能墙体的平面内与平面外力学性能研究。
Objective To investigate the effects of steady shear flow on the deformation properties of an adherent leukocyte and its nucleus.
目的研究稳定剪切流动对黏附于血管表面的白细胞及其细胞核变形的影响。
Flow properties of a waxy crude are influenced by shear history.
含蜡原油的流变性与其所经历的剪切历史有关。
The said grease possesses high dropping point and good colloidal and shear stability as well as good anti corrosion, water resistance and anti wear properties.
制备的复合锂-钙基脂具有高滴点和良好的胶体安定性、剪切安定性，良好的抗水性、防腐性和润滑性。
The said grease possesses high dropping point and good colloidal and shear stability as well as good anti corrosion, water resistance and anti wear properties.
制备的复合锂-钙基脂具有高滴点和良好的胶体安定性、剪切安定性，良好的抗水性、防腐性和润滑性。
应用推荐