Multi vertical line element model is the most widely used model in the nonlinear analysis of shear wall structures.
多垂直杆元模型是目前最为常用的一种用于剪力墙结构非线性分析的宏观模型。
This paper deals with the interaction between shear wall and its foundation using finite element method.
本文采用有限单元法对建在多层地基上的剪力墙， 基础和土进行了共同作用分析。
A hyper finite element method applied to the structural analysis of shear wall is presented which is a new numerical method used for analyzing large scale complicated structure.
提出了一种用于剪力墙结构分析的超级有限元方法。超级有限元法是一种用于分析大型复杂结构的新的数值方法。
As a new lateral resisting element, steel plate shear wall with vertical slits has favorable integrative benefits.
带缝钢板剪力墙作为一种新型的抗侧力构件，有着良好的综合效益。
Through experimental study and finite element analysis, we draw that the vertical holes in the hollow shear wall structure with seams lessen self-weight so as to lower the earthquake action.
试验研究和有限元分析得出：此种带缝空心钢筋混凝土剪力墙结构中竖向孔洞的存在减轻了结构的自重，因而降低了结构的地震作用。
Combined with element model with varied stiffness in different regions, nonlinear seismic response of shear wall with large or small opening holes was analyzed.
该模型可直接用于小开洞剪力墙的分析，结合分段变刚度单元，分析了大、小开洞剪力墙的非线性地震反应。
A finite element model for nonlinear dynamic analysis of reinforced concrete block shear wall is pointed out.
本文提出了配筋砼砌块剪力墙非线性动力分析有限元模型。
Shear wall is the structural element that resists lateral force.
剪力墙是一种抵抗侧向力的结构单元。
With the results of the multi-ribbed wall tests and finite element analysis, the shear capacity formulas of a oblique section based on ultimate balance theory are given.
并在试验结果与有限元模拟的基础上，依据极限平衡理论，建立起来复合墙体的斜截面抗剪极限承载力公式。
Combining with three nodes isoparametric axial force element, the new element can be used to accurately calculate the shear flow action between bar and skin in thin-wall structure.
它与三节点等参轴力杆单元组合时可以精确地模拟薄壁结构中杆与蒙皮之间的剪流作用。
Tie beam is an important element in frame-shear wall structure.
连梁在框架-剪力墙结构中，也是很重要的一个构件。
The wall shear stress caused by cement slurry flowing in the annular space is a key element that affects the displacing efficiency.
水泥浆环空流动的壁面剪应力是影响顶替效率的关键因素。
Finite element analysis shows that the lateral stiffness of the concrete grill wa ll can be calculated by an equivalent solid shear wall with the thickness of two third of the original wall thickness.
有限元分析结果表明，保温砌模混凝土墙的抗侧刚度可用厚度为其三分之二的等效实体墙计算或用小开口整体墙计算。
Aimed at the steel shear wall with slit, a systematic research is done on the forced performance. By using the finite element soft ware ANSYS, the paper analyzes this lateral resistant member.
针对带缝钢板剪力墙，本文对其受力性能进行了系统研究，并用有限元软件ANSYS进行了分析。
During the finite element analysis of shear-wall with opening in high-rise buildings, how to select an appropriate plate element model possesses important significant for software users.
在高层建筑开洞剪力墙有限元分析中软件用户面临不同板单元模型的选取问题。
Finally, these element models were utilized for the analysis of shear-wall with opening in high-rise buildings.
最后利用这些模型分析了高层建筑开洞剪力墙问题。
Incorporating with the model dynamic experiment and Finite-Element seismic analysis of a shear-wall superhigh building, paper gives the earthquake resistant behavior of such structures.
本文结合一超高层钢筋混凝土剪力墙一核心筒结构的模型试验与有限元动力分析，对超高层筒体结构的动力特性作了具体研究分析。
The numerical simulation and analysis of shear resistance behavior of two-side connected steel-plate shear wall (SPSW) was carried out by the finite element software ANSYS.
采用ANSYS有限元程序对两边连接钢板剪力墙进行数值模拟分析。
The Experimental Study and Finite Element Analysis on Seismic Behavior of Hollow Shear Wall of R. C. Structure with Seams.
带缝空心r.c。剪力墙结构抗震性能试验研究及有限元分析。
The use of large-scale general-purpose finite element analysis software on the short-limb shear wall structural walls were cracking component simulation analysis.
利用大型通用有限元分析软件对短肢剪力墙结构墙肢构件进行了开裂模拟分析。
The finite element model of steel plate shear wall with silts in frame is established and by which the effect of main silt parameters on its strength and stiffness is analyzed.
建立了带框架的开缝钢板剪力墙有限元模型，分析了主要开缝参数对其强度和弹性刚度等性能的影响。
In this paper, the shear behavior of a new type of high-strength cold-formed ultra-thin-wall steel wall frame was analyzed mainly by the finite element method.
采用了有限元法对冷弯薄壁型钢单榀墙架结构的进行受剪性能的分析。
In this paper, the shear behavior of a new type of high-strength cold-formed ultra-thin-wall steel wall frame was analyzed mainly by the finite element method.
采用了有限元法对冷弯薄壁型钢单榀墙架结构的进行受剪性能的分析。
应用推荐