Sources generate event messages that are ultimately published to the bus through the WebSphere Sensor Events gateway.
消息源生成事件消息，这些消息最终通过WebSphereSensorEvents网关发布到总线。
The design and networking method of network sensor based on RS-485 bus are introduced. The design example of hardware circuit and software are also given.
介绍了一种基于rs—485总线的网络传感器的设计与组网方法，并给出了软硬件设计实例。
CMOS digital image sensor and PIC18F4550 micro-controller with USB bus are applied to this sys - tem instead of the analog CCD camera to realize the digital acquisition and intelligent transmission.
系统运用CMOS数字图像传感器取代模拟CCD摄像机，采用带有usb总线的PIC18 F 4550单片机来控制和传输数据，实现了视觉检测前端数据采集与传输的数字化、智能化。
A signal acquisition card for inductance sensor based on PCI bus is designed in this paper.
研制了一种基于PCI总线的电感传感器信号采集卡。
This subject designs the detection system, including mainframe program, auxiliary machinery hardware and program, system bus and sensor design.
本课题完成总线检测系统的完整设计，包括主机软件、从机硬件和软件、总线以及传感器电路设计。
This paper introduces the principle of the intellectual single bus temperature sensor DSI8B20, and proposes a kind of design plan for computer's temperature controlling system based on DSI8B20 sensor.
介绍了单线总线智能温度传感器DSI8B20的原理，提出了一种基于DSI8B 20传感器的电脑温度控制系统的设计方案。
The sensor uses two revolving transformers to transfer the electrical source and the signal without contacting. It also implements remote monitoring tests through the field bus technology.
该传感器使用两组旋转变压器实现了电源及信号的非接触传递，并通过现场总线技术实现远距离测试监控。
The grating sensor interface which is based on PCI bus of this paper has a lot of merits, such as miniaturized, portable and intelligent and so on.
本文设计的基于PCI总线的光栅传感器接口卡具有小型化、便携式智能化等优点。
The design of the whole hardware circuit, including theCPLD processing of the sensor signal, the PCI bus inter-face circuit is introduced.
详细介绍了整个系统的硬件电路设计，包括光栅传感器信号的CPLD处理、PCI总线接口电路设计；
This topic research based on single bus STC89C52 single-chip microcomputer and the digital temperature sensor DS18B20 multi-spot temperature measuring system.
本课题主要研究基于STC 89c52单片机与单总线DS18B 20数字温度传感器的多点温度测量系统。
Then a CAN bus networked sensor is designed based on this model.
然后基于这个模型设计了CAN总线网络化传感器。
The hardware parts of the sensor adopt the system with dual MCU and dual bus, and each dual MCU system exports the results by its respective communication bus.
该传感器的硬件采用了双单片机和双总线系统结构，每一个单片机系统都通过各自的通讯总线将处理结果输出。
Besides, several or more digital sensors can be connected to the can BUS and make up a sensor test and control network in order to realize the digital sensor network.
可在CAN总线上挂接多个数字传感器，组成传感器测控网络，实现数字传感器的网络化。
Secondly, the CAN bus control system for controlling multi-sensor visual measuring system is carefully structured.
其次，为了控制多传感器视觉测量系统而构建了CAN总线控制系统。
The paper introduces application of STD Bus microcomputer in detection system for temperature of axle by using infrared sensor, and gives the system block diagram of hardware and software.
本文介绍了STD总线在红外轴温检测系统中的应用情况，给出了红外轴温检测系统的硬件组成和软件的设计框图。
This article introduces a kind of intelligent sensor node in measuring and controlling system based on CAN bus.
本文介绍了一种基于CAN总线的测控系统智能传感器的硬件设计方案。
The wireless data transmission system which is composed of wireless data transmission device nRF24L01 and high-precision 1-Wire bus digital temperature sensor DS18B20, is introduced in this paper.
介绍一种由nRF24L01型无线数据传输器和高精度的单总线数字温度传感器DS18B20组成的无线数据传输系统；详细阐述该系统的硬件和软件设计要点；
When it connects to ARM, driving circuits (sequential logical circuits) is necessary because CMOS star sensor doesn't belong to I2C bus circuits.
CMOS敏感器不是I2C总线电路，因此同arm连接必须有驱动电路(时序逻辑电路)。
The data from the sensor gets read back together with all the other bus lines. This process occurs simultaneously with the write process.
从传感器反馈回来的数据在其他的数据总线上重复执行，这个进程和写的进程同时发生。
Guangzhou used Ozon sensor technology for single-bus temperature and humidity sensors DHT11.
所用传感器为广州奥松科技的 单总线温湿度传感器DHT11。
Test results prove the CAN field-bus sensors's sound data acquisition performance and it meet the requirement of smart sensor module.
测试结果验证本温度智能传感器的性能良好，达到了智能传感器模块的要求。
An intelligent temperature and humidity sensor with CAN Bus and detecting part of digital temperature and humidity sensor SHT75 is presented.
介绍了以数字式温湿度传感器SHT75为检测器件，带CAN总线的智能温湿度传感器的设计。
Besides, simulated waveform in time domain and spectrum with different length sealing bus, and developed a non-contact generator stator sensor based on the former characteristic.
此外，还针对不同长度的封闭母线仿真了时域波形及频谱的变化，并针对上述规律开发了一种非接触式发电机定子局部放电传感器。
Based on capacitive fingerprint sensor and USB bus interface, the capturing apparatus of fingerprint is designed and high quality of images is assured.
针对指纹识别中的指纹采集和预处理这两个关键问题，设计并实现了US B电容式指纹采集仪，保证了指纹图像采集的高质量。
It is critical technology to encode the digital sensor DS18X20 that measure multiple temperatures with the 1-wire bus.
运用数字式传感器ds18 X 2 0采取单信号传输线进行多点测温的关键技术是传感器的地址编码问题。
Design of synchronous cycle trig based on internal bus, consensus definition of sensor sampling and actuator timing and precise data transmission model ensured the synchronization performance.
设计了基于内部总线的同步周期触发，定义了一致的传感器、执行器单元执行时序，以及精确光纤链路数据传输模型，确保测控的高同步性。
Based on CAN bus control system, distributed network control of multiple visual sensor was realized. It specially suitable to realtime control of large scale multiple sensor visual...
文章介绍的CAN总线控制系统实现了多视觉传感器的分布式网络化控制，尤其适合对实时性、可靠性和精度等要求较高的大型多传感器视觉测量系统的实时控制。
DS18B20 is a single-wire digital thermo-sensor made by DALLAS. Multiple DS18B20s can be connected to a microprocessor to communicate via the same single-wire bus.
DS18B20是DALLAS公司生产的数字温度传感器，多个传感器可通过一根口线与微处理器相连。
DS18B20 is a single-wire digital thermo-sensor made by DALLAS. Multiple DS18B20s can be connected to a microprocessor to communicate via the same single-wire bus.
DS18B20是DALLAS公司生产的数字温度传感器，多个传感器可通过一根口线与微处理器相连。
应用推荐