Various reverse transcriptase–polymerase chain reaction (RT–PCR) methods are available but are of variable sensitivity.
有各种逆转录酶聚合酶链反应(扩增核糖核酸基因组RT–PCR)检测试验方法，但灵敏度各不相同。
Acoustic-Structure sensitivity is used to predict the change of acoustic pressure when structure design variable was changed, which is significance for reducing noise of structure.
声学-结构灵敏度用于预测结构辐射声压随结构设计变量的变化，该值对结构降噪设计有重要意义。
The dynamic characteristics of multi-variable system under parameter perturbations are analysed by System Sensitivity Theory in this paper.
本文运用系统敏灵度理论分析了多变量系统在参数摄动条件下的动态特性。
Sensitivity analysis allows you to consider the effect of changing one variable at a time.
敏感性分析允许你考虑一次改变一个变量造成的效果。
The adjoint variable method for design sensitivity analysis of multibody system dynamics based on ordinary differential equations is presented.
基于常微分方程数学模型建立了多体系统动力学设计灵敏度分析的伴随变量方法。
Its frequency response is calculated by use of FEM and its vibration velocity sensitivity with respect to its local thickness as a design variable is computed.
基于有限元直接法计算振动板的频率响应，以板局部厚度为设计变量，计算了振动速度对局部板厚度的灵敏度；
Objective: To reduce the risk of 3 -terminal mismatch between primers and template and increase the sensitivity of polymerase chain reaction (PCR) in the detection of variable region of DNA.
目的：通过使用3末端碱基游移混合引物，减少引物末端错配，提高多变区基因片段的PCR检测阳性率。
Variable-gapcapacitance sensor has high sensitivity, specially applying to non-contact measurement of micro displacement, and slightly affecting the system to be measured.
变气隙式电容传感器具有灵敏度高、特别适用于微小位移的非接触测量，对被测系统影响小。
This article defines the sensitivity of dispersed variable. And we can use it to analyze the order of a infinite and judge the convergence of a constant term series.
给出离散变量的灵敏度之定义，且通过变量的灵敏度分析无穷大量的阶，从而判断常数项级数的敛散性。
The disk structural reliability is calculated by use of Monte Carlo Simulation ( MCS ) techniques and Response Surface Method (RSM). The random variable sensitivity is also analyzed.
分别采用蒙特卡罗法和响应面法计算了轮盘结构可靠度，并对其随机性的影响因素进行了灵敏度分析。
The optimization procedure of preform die shape is given. The sensitivity of nodal velocity and temperature with respect to design variable is developed.
给出了模具形状优化设计步骤，推导了速度灵敏度方程和温度灵敏度方程。
The optimization procedure of preform die shape is given. The sensitivity of nodal velocity and temperature with respect to design variable is developed.
给出了模具形状优化设计步骤，推导了速度灵敏度方程和温度灵敏度方程。
应用推荐