The study provides effective numerical analysis method and theoretical basis for the design and optimization of automobile semi axle cross wedge rolling.
研究结果为优化和设计汽车半轴楔横轧设备提供了有效的数值分析方法和理论依据。
The effect of temperature on ultimate axle load of semi-rigid asphalt pavement was explored through theoretical analysis on a typical structure at various temperatures.
在不同的环境温度下，通过对典型结构的理论分析，探讨温度变化对半刚性沥青路面极限轴载的影响。
Although it fails in a sense, the semi-rigid asphalt pavement may not lose its bearing capacity under the application of the ultimate axle load.
虽然在某种意义上有破坏，半刚性沥青混凝土路面在极限轴载作用后不一定丧失承载能力。
The results show that stress in hollow beam and semi-shaft bush is much less than permissible stress, while joint of suspension frame and axle housing has too large local stress.
结果表明，驱动桥壳空心梁和半轴套管部分的应力远小于材料的许用应力，而悬架支座与桥壳连接处出现了局部应力过大的情况。
This paper introduced a plan to transform 64D semi-automatic section block into one with Axle Counter . And, it also illustrated relevant relays and its circuit.
介绍了6 4D半自动闭塞改造为计轴自动站间闭塞的一种方案，对有关继电器及其电路进行了说明。
Analyzed the mechanical characteristics of semi-lean solution pump and crippling cause of axle bearing, some relative measures were given.
针对断轴特征，通过对半贫液泵进行综合分析，找出其断轴原因，并制定出解决断轴的对策。
The SIF and its correction factor of the transverse surface semi-elliptic crack of a photoelastic axle are tested and studied with the method of three dimensional photo-elastics.
通过三维光弹实验测定了轴表面横向半椭圆裂纹的应力强度因子（SIF），并计算了与光弹轴裂纹几何及当地应力相对应的无限大体的SIF，从而求得SIF修正系数。
New rotary rolling technology, equipment selection and die design for Model EQ140 auto semi-axle has been introduced.
介绍了EQ 140汽车半轴摆辗新工艺、设备选择及模具设计要点。
A new precision forming technology was presented, which uses an ordinary forging machine and a high precision rotary forging machine to make the closed-tolerance semi-axle bevel gear forgings.
论述了精锻汽车差速器半轴齿轮原模具结构存在的问题，改进了锻造工艺和锻件设计，设计了新型粗锻模和精压模。
A semi-annular bearing with an opening is used to support both ends of inside engaged gear or for fixed-axle gear box.
留有开口的半环形轴承，用于内啮合齿轮双端支承及定轴齿轮箱。
A semi-annular bearing with an opening is used to support both ends of inside engaged gear or for fixed-axle gear box.
留有开口的半环形轴承，用于内啮合齿轮双端支承及定轴齿轮箱。
应用推荐