Through experiment, KNO3 is thought a better electro-polymer medium, Moreover. the good parameters of scanning number. Scanning rate and scanning voltage range were determined.
通过实验，确定KNO3为较好的电聚合介质，以及较好的扫描速率、扫描次数、扫描电压范围。
Scanning tunneling microscope (STM) work by the voltage added to the microscope probe tip and the ends of the scanned object and then detect current changes.
扫描隧道显微镜(STM)的工作方式是把电压加到显微镜探头尖端与被扫描物体这两端，然后检测电流变化。
An STM works by applying a voltage between the microscope's tip and the material it is scanning, and then monitoring the change in current.
扫描隧道显微镜(STM)的工作方式是把电压加到显微镜探头尖端与被扫描物体这两端，然后检测电流变化。
This approach works well for simple voltage measurements, scanning through a few channels, making the measurements, and passing the data to the PC for analysis.
如果用来进行小电压信号测量，在多个通道进行扫描，进行测量并将数据传送倒PC进行分析这样的工作，基于PC的仪器可以很好的应付。
A voltage scanning module was designed and fabricated to carry out the cyclic voltammetric detection.
设计并制作了用于循环伏安法的扫描电压模块。
Line, field scanning circuit as needed to provide the picture of voltage.
行、场扫描电路为显像管提供种种所需要的电压。
Micromorphology and fine structure in laser hardened layer of grey cast iron have been investigated with scanning electron microscope and high-voltage transmission electron microscope.
用扫描和高压透射电子显微镜研究了灰铸铁激光硬化层微区组织形貌和精细结构。
Subsequently, the breakdown happened inside of the high-voltage vacuum apparatus was researched initially by means of scanning electron microscope analysis and vacuum apparatus dissection.
采用高压真空器件解剖、扫描电镜分析和高压脉冲耐压试验分析了高压真空器件内的真空击穿、陶瓷击穿。
Also, computer simulation is conducted to work out the contrast curve of scanning spots and the offset voltage across the modulation unit of the optical phased array.
最后通过计算机模拟计算，得出扫描点的对比度曲线以及相控阵调制单元上所加的补偿电压。
The formation and characteristics of the wave of electricity and voltage in proper route and adverse route in TV scanning was analyzed; The measure methods of OTL circuit were introduced;
分析了电视机场扫描正程和逆程中电流、电压的波形形成和特点；
Methods a dis continuous buffer system was used. CK MM isoform was separated by electrophoresis under the condition of constant current and low voltage, then fluorescence scanning.
方法采用不连续缓冲体系，在稳流低压条件下电泳分离CKMM亚型，荧光扫描。
A single chip Liquid Crystal Display (LCD) driver chip is developed based on dynamic scanning, which is a high voltage CMOS digital and analog mixed signal IC.
文章介绍了一种基于动态扫描原理的液晶显示(LCD)驱动芯片，该芯片为高压CMOS数模混合集成电路。
A single chip Liquid Crystal Display (LCD) driver chip is developed based on dynamic scanning, which is a high voltage CMOS digital and analog mixed signal IC.
文章介绍了一种基于动态扫描原理的液晶显示(LCD)驱动芯片，该芯片为高压CMOS数模混合集成电路。
应用推荐