Injecting complementary light can shorten SOA gain recovery time, while amplifying saturated power improves the wavelength converting efficiency.
注入的辅助光可以缩短soa增益恢复时间，增大饱和功率，提高波长转换效率。
Increasing the thickness of films will enhance the peak of PL, and there is a saturated thickness at the constant pump power by Laser.
而薄膜厚度的增加有利于退火后光致发光的峰值光强增加，但是对于一定的泵浦功率存在饱和厚度。
The changes of the step amplitude in non-linear dual step circuits are emphasized which affect saturated output power.
重点研究了非线性双跳变电路中跳变幅度的变化对饱和输出功率的影响。
Two very pithy and powerful analytical expressions for saturated signal gain and signal output power of fiber optical parametric amplifiers are educed with numerical analysis.
通过数值分析的方法推导出光纤参量放大饱和信号增益和信号输出功率的数学表达式。
When pump power increases farther, second Stokes wave is generated, then first Stokes wave is saturated, and residual pump wave power starts to be increasing linearly.
抽运功率继续增大，第二级斯托克斯波产生后，第一级斯托克斯波功率达到饱和，剩余抽运功率又开始线性增长。
GMSK schemes typically transmit in a saturated mode in which transmitted data is output from the pa with a constant amplitude as measured by power versus time during the useful part of the burst.
GMSK方案一般在饱和模式下进行发射，其中在脉冲串的有用部分期间，功率放大器以功率幅度不随时间变化的方式发送数据。
Described is a method of superheated steam regulation for the heat recovery boiler of a gas steam combined cycle power plant, the so called boiler drum saturated steam attemperation.
介绍了燃气—蒸汽联合循环电站余热锅炉过热蒸汽调温的一种方法—自身饱和蒸汽减温。
A sacred fount of untold power, It 'saturated every fiber of our being.
一眼浸润我们每个人血管的无尽的力量之泉。
Heat evolution correction method for node of the saturated steam network was put forward, which can be used for simulation for large-scale steam network of nuclear power plant.
针对单相可压缩流体网络模型提出了饱和蒸汽网络节点散热修正方法，可以用于核电站等大型蒸汽管网的仿真计算。
Controllable saturated reactor is widely used in dynamic reactive power compensation, induction motor soft-starting and fault line selection of small current grounding system.
可控饱和电抗器在动态无功补偿、电机软启动、小电流接地选线等方面具有广阔的应用前景。
The heights of these microripple structures varied from 10 nm to 300 nm by increasing the laser power and saturated at a higher laser power.
这些微突起结构离开样品表面的高度为10～300nm不等，并且随着激光功率的增大而增加，在一定功率下达到饱和状态。
The heights of these microripple structures varied from 10 nm to 300 nm by increasing the laser power and saturated at a higher laser power.
这些微突起结构离开样品表面的高度为10～300nm不等，并且随着激光功率的增大而增加，在一定功率下达到饱和状态。
应用推荐